ENGINE AR 3592116 - Caterpillar

Illustration 1. The two joystick patterns available for machines shipped outside of Japan.All machines shipped to NACD (North American Commercial Division) will still be connected for the standard excavator pattern. However, if requested by users, the optional backhoe pattern can be obtained by reconnecting the pilot hoses as shown herein.
If the joystick control pattern is changed, the existing control pattern film must be replaced with the correct pattern film. And, if not already installed, put on a new warning film and instructional film. See following procedure.
Caterpillar recommends and supports only the standard excavator and backhoe patterns as shown in Illustration 1. NO OTHER patterns should be installed.
Do the following steps to change the joystick pattern from the standard excavator pattern to the backhoe pattern, or vice versa. The new films required are: 7Y0007 Joystick Instruction Film (Standard-Cat Excavator) or
9X1771 Joystick Instruction Film (Optional-Backhoe)9X5980 Warning Film9X5955 Control Pattern Instruction Film
1. Lower implements to the ground and shut off engine.2. With pilot control neutralizing lever in the DOWN or OPERATE position, operate pilot controls to discharge the pilot system accumulator.3. Remove existing control pattern film and apply the new film that is correct for the new pattern to be used. See Illustration 2.
Illustration 2. Location of control pattern that must be changed, and the warning film which may be needed on some units.4. A 9X5980 Warning Film should be located inside the cab as shown in Illustration 2. This film is installed on some machines.For E70B, E110B, E120B, E200B, EL200B Excavators
5. Remove the protective cover from under the main frame beneath the cab. See Illustration 3. Install the 9X5955 Instruction Film if it is not installed. It shows pilot hose connections for both patterns, and tells the user to contact the Caterpillar dealer before switching the hoses again.
Illustration 3. Location of the instruction film.
As a precaution, note how the hoses are connected. The hoses are labeled with aluminum tags and color bands. Refer to Charts A and B for identification codes and colors.
6. Remove hose brackets from the pilot control valve side of the connectors (front of machine).7. To change from one joystick pattern to the other pattern, switch the positions of the four following quick couplers on the pilot control side of the connector, which is toward the front of machine (see Illustration 4): ...Switch pilot control side connectors L1 and R3.
...Switch pilot control side connectors L3 and R1.
This will switch the stick and boom functions.
Illustration 4. Locations of the four pilot hose connectors that are exchanged on E70B, E110B, E120B, E200B, EL200B.8. Reinstall hose brackets and protective cover.9. Operate the excavator in an open area to be sure the implement operation matches the desired pattern.For E240B, EL240B, E300B, EL300B Excavators
5. Open the access door behind the operator compartment. See Illustration 5. The pilot lines extend rearward from the bulkhead panel to the main control valve.
Illustration 5.
As a precaution, note how the hoses are connected. The hoses are labeled with aluminum tags and color bands. Refer to