ENGINE AR-COMPLETE 3599207 - Caterpillar

Illustration 1 g01197980
Monitor Panel (1) Up key (2) Right key (3) Home key (4) Main menu key (5) Left key (6) Down key (7) Cancel key (8) OK keyTable 2 contains parameters for the tool control of the system 3.
Table 1
DISPLAY    "TOOL #1"    "TOOL #2"    "TOOL #3"    "TOOL #4"    "TOOL #5"    
"TOOL PROGRAM: GENERAL"    
"NAME"     H160C     H180C     0     0     0    
"MAX DIAL"     10     10     10     10     10    
"MIN DIAL"     1     1     1     1     1    
"UNDERSPEED ENABLE"     ENABLED     ENABLED     ENABLED     ENABLED     ENABLED    
" HYD TEMP"     80     80     80     80     80    
"COMBINER ENABLE"     ENABLED     ENABLED     ENABLED     ENABLED     ENABLED    
"TOOL PROGRAM: ATTACHMENT #1 VALVE"    
"A1 FLOW"
Flow setting of the attachment valve A1     280.0     280.0     250.0     250.0     250.0    
"A1 MULTI ADD FLOW"
Additional oil flow for the A1 circuit     0.0     0.0     0.0     0.0     0.0    
"A1 NOMINAL PRES"
Normal working pressure for the A1 circuit     16000     16000     16000     16000     16000    To access the tool parameters, enter the service mode on the monitor.
From the default screen, press the main menu key (4) .
From the "MAIN MENU" screen, use the right key (2) to scroll through the menu options.
When the "SERVICE" option is highlighted, press the OK key (8) .
When "PASSWORD" screen appears, use the right key (2) and the left key (5) in order to scroll through the characters. When the desired character is highlighted, press the OK key (8) . Enter the password for service FFF2 in order to continue to the "SERVICE" screen.
After the password has been entered the "SERVICE" screen should appear. Refer to Illustration 2.Note: For more detailed steps with entering passwords or entering the service mode, refer to Troubleshooting, "Using Service Mode" for the Tool Control System.
Illustration 2 g01131368
Illustration 2 is a typical example of the "SERVICE" screen.Table 3 shows some of the approved Caterpillar work tools that are used. The table lists some of the parameters that should be verified for successful operation of the work tool.
Table 2
SYSTEM 3    
Work Tools     Direction of Flow     System 3"TOOL#s"     Parameters to Verify    
Hammer
H160C
H180C     1 Way     All "TOOL#s"