ENGINE AR-COMPLETE 3679597 - Caterpillar

Illustration 1 g01401058
(1) Torque for the terminal bushings ... 95 7 N m (70 5 lb ft) (2) 9L-9424 Spring Length under test force ... 7.16 mm (0.282 inch) Test force ... 1.0 0.0 N (0.176 0.010 lb) Approximate free length after test ... 11.05 mm (0.435 inch) Maximum outside diameter ... 9.96 mm (0.392 inch) (3) 9N-5862 Spring Length under test force ... 35.13 mm (1.383 inch) Test force ... 56.7 6.6 N (12.7 1.5 lb) Free length after test ... 40.80 mm (1.606 inch) Outside diameter ... 18.49 0.25 mm (0.728 0.010 inch) (4) Torque for bolts ... 2.70 0.25 N m (24 2 lb in) (A) Length of the new pump plunger ... 43.2691 0.0051 mm (1.70350 0.00020 inch)
Illustration 2 g01401061
(5) Service meter drain (6) Governor housing drain (7) Fuel inlet (8) Screw (high idle adjustment) (9) Bolt (low idle adjustment) (10) Transfer pump drain (B) Distance with control shaft assembly in contact with lever shaft ... 2.83 0.50 mm (0.111 0.020 inch) (D) End play of the camshaft with the camshaft sleeve bottomed on the camshaft, as shown. ... 0.58 0.46 mm (0.023 0.018 inch) (11) When the camshaft sleeve is assembled onto the camshaft, the camshaft must be supported in order to prevent damage to internal parts.
Illustration 3 g01401059
Section C-C (12) Lightly lubricate the bore for the O-ring seal with the lubricant that is being sealed.
Illustration 4 g01401063
(13) 9S-8632 Spring Length under test force ... 30.5 mm (1.20 inch) Test force ... 180 18 N (40 4 lb) Free length after test ... 50.8 mm (2.00 inch) Outside diameter ... 22.35 mm (0.880 inch) (14) 4N-0527 Spring Length under test force ... 8.71 mm (0.343 inch) Test force ... 0.85 0.08 N (0.2 0.0 lb) Free length after test ... 18.29 mm (0.720 inch) Outside diameter ... 9.14 mm (0.360 inch)
Illustration 5 g01401062
Section E-E (15) 4N-0605 Spring Length under test force ... 22.35 mm (0.880 inch) Test force ... 15.70 0.80 N (3.5 0.2 lb) Free length after test ... 43.92 mm (1.729 inch) Outside diameter ... 13.39 mm (0.527 inch)