ENGINE AR-CORE 3767017 - Caterpillar

Do not disconnect any air lines from the centershift lock control valve until the air pressure is zero.
Typical Example2. Remove the cotter pin and pin (3) from linkage (5). Move the linkage free of the handle. Remove bolts (2) and retainer (1) from the cover. Remove bolts (4) and cover (6).
Typical Example3. Disconnect air lines (9) and (10) from the valve.4. Remove screws (7). Remove centershift lock control valve (8). The following steps are for installation of the centershift lock control valve.1. Put centershift lock control valve (8) in position on the support. Install the screws that hold it.2. Connect the three air lines (9) and (10) to their correct location on the valve (8).3. Put cover (6) in position on the brackets. Install bolts (4) that hold it.4. Put retainer (1) in position on cover (6). Install bolts (2) that hold it.5. Put linkage (5) in position on the handle. Install pin (3) that holds it. Install the cotter pin.Disassemble And Assemble Centershift Lock Control Valve
Start By:a. remove centershift lock control valve 1. Remove pin (4) that holds lever (3) to body (1). Remove lever (3).2. Remove two plungers (2) and springs (5) from the body. Remove the O-ring seals from the plungers. 3. Remove bolts (6) and cover (8) from body (1). Remove O-ring seal (9) from the cover.4. Remove springs (7) and valves (10) from the body. The following steps are for assembly of the centershift lock control valve. 5. Install O-ring seal (9) in cover (8). Install O-ring seal (11) on plungers (2).6. Put two springs (5) in position on two plungers (2). Put two plungers (2) in position in body (1).7. Put lever (3) in position on the body. Install the pin (4) that holds it.8. Put two valves (10) and two springs (7) in position in the body (1).9. Put cover (8) in position on the body (1). Install the bolts (6) that hold it.End By:a. install centershift lock control valve