ENGINE AR-COMPLETE 3904671 - Caterpillar

Monitor Procedure
The following procedure will allow the user to select one of the ten work tools that are programmed into the monitor and machine ECU.
Illustration 1 g03583758
The "Home" screen of the monitor is displayed when the key switch for the machine is turned to the ON position. Press the "Menu" key to display the main menu options.
Illustration 2 g03583761
Use the arrows to select "Work Tool Select" from the "Main Menu". Press the OK key.
Illustration 3 g03583762
Use the arrows to highlight the desired work tool from the "Work Tool Select" menu. Press the OK key to select the work tool. Note: The selected work tool will now appear in the message bar at top of the monitor screen.
Illustration 4 g03583764The selected work tool will now appear at the bottom of the Home Screen.Note: To change the parameters of the work tool, refer to Testing and Adjusting, "Work Tool Parameter - Program" for more information.Cat Electronic Technician Procedure
The following procedure will allow the user to select one of the ten work tools that are programmed into the machine ECU using Cat Electronic Technician.
Illustration 5 g02713701
Diagnostic connector for Cat Electronic Technician
Connect the Cat Electronic Technician to the diagnostic connector located behind the operator seat of the cab.
Illustration 6 g02713758
Start Cat Electronic Technician.
Illustration 7 g02713761
Select the ECU for "Machine Control".
Illustration 8 g02714358
Select "Tool Configuration" from the "Service" menu.
Illustration 9 g02722754
Work tool list (typical example)
Highlight the desired tool. Click on "Activate" in the bottom left corner of the screen. The selected tool will now be listed as the "Active Tool" at the top of the screen. Note: To change the parameters of the work tool, refer to Testing and Adjusting, "Work Tool Parameter - Program" for more information.