ENGINE AR-COMPLETE 4549462 - Caterpillar

4549462 ENGINE AR-COMPLETE Caterpillar parts

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA4549462
454-9462
4549462

Buy ENGINE AR-COMPLETE 4549462 Caterpillar genuine, new aftermarket tractor parts with delivery

For full view, you need register

Information:

Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire. To help prevent possible injury, turn the start switch off when changing fuel filters or water separator elements. Clean up fuel spills immediately.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Do not allow dirt to enter the fuel system. Thoroughly clean the area around a fuel system component that will be disconnected. Fit a suitable cover over disconnected fuel system component.
Do not fill fuel filters with fuel before installing them. The fuel will not be filtered and could be contaminated. Contaminated fuel will cause accelerated wear to fuel system parts. The fuel system should be primed prior to starting the engine.
Illustration 1 g03506426
(1) Drain valve (2) Filter (3) Filter base (4) Water-in-fuel sensor (optional)Note: Refer to Operation and Maintenance Manual, "General Hazard Information" for information that pertains to containing fluid spillage.Note: Drain the water and sediment into a suitable container. Dispose of fluids according to local regulations.
Prepare a suitable container to catch fluid. Turn drain valve (1) counterclockwise to open. Drain fluid from the filter/water separator.
Close the drain valve.
Remove sensor (4) .
Remove filter (2) from filter base (3). A filter wrench may be used to loosen the filter.
Discard the used filter.
Install a new filter into the filter base. Securely hand-tighten filter to base.Note: Instructions for the installation of the filter are printed on the side of each Cat spin-on filter.
Install sensor (4) .