AVSPARE.COM
parts catalog

ENGINE AR 4W0860 - Caterpillar


4W0860 ENGINE AR Caterpillar parts 3208
Rating:
9
Alternative (cross code) number:
CA4W0860
4W-0860
4W0860
Caterpillar 4W0860 ENGINE AR

Buy ENGINE AR 4W0860 Caterpillar genuine, new aftermarket tractor parts with delivery
INDUSTRIAL ENGINE,

Related part:
4W0860  LONG BLOCK M  0R0969  R
4W0860  SHORT BLOCK  0R1153  R

You can buy:

 
5000

05 Nov 2017
MW Motoren & Ersatzteilhandel GmbH

Compatible equipment models: 4W0860:

INDUSTRIAL ENGINE  3208   Caterpillar
  For full view, you need register

Information:

Assembly Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 1P-2321 Combination Puller 1
B 1P-0510 Driver Group 1
Illustration 1 g01103246
Use Tooling (B) to install sleeve bearings (4) in pump body (3). The bearing joint should be 30 15 degrees from the center line of the two bearing bores. Install the sleeve bearings so the sleeve bearings are even with the outside of the pump body.
Illustration 2 g01101732
Use Tooling (B) to install sleeve bearings (11) in cover (10). The bearing joint should be 30 15 degrees from the center line of the two bearing bores. Install the sleeve bearings so the sleeve bearings are even with the outside of the cover.
Illustration 3 g01101672
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Lubricate idler gear (12) and drive gear (13) with clean engine oil. Lubricate sleeve bearings (4) with clean engine oil.
Install idler gear (12) and drive gear (13) in pump body (3).
Lubricate sleeve bearings (11) with clean engine oil.
Install cover (10) and bolts (9).Note: The engine oil pump must turn freely after assembly. Turn the engine oil pump by hand. Reposition cover (10) if the engine oil pump does not turn freely.
Install relief plunger (7), spring (6), retainer (5), and bolts (8).
Install the woodruff key on the shaft of the engine oil pump.
Illustration 4 g06302676
Install drive gear (1) on the shaft of engine oil pump (2) and install the bolt. Tighten the bolt that holds drive gear (1) to engine oil pump (2) to a torque of 55 10 N m (41 7 lb ft).End By:
Install the engine oil pump.

Caterpillar parts catalog:

Caterpillar parts catalog
3208 INDUSTRIAL ENGINE 03Z00001-10092


Parts engine Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.