ENGINE AR-COMPLETE 5062266 - Caterpillar

During station transfer, the requesting control station gear selection is not the same as the active station.If the gear remains not qualified for over 10 seconds, then the "Gear Not Qualified" diagnostic alarm shall be activated and the affected gear will be set to neutral.Troubleshooting:The gear is not qualified for the active control station. This diagnostic code will occur on the active station only. This diagnostic code could be an indication of operator error. In case of operator error, this diagnostic code may not indicate a problem with the control system.This diagnostic code will only occur on the active control station. If this diagnostic code is active when an integrated control head is the active station, replace the integrated control head. Continue with this procedure if the diagnostic code is active when a slim line control head or a side mount control head is the active station.Note: Return the gear selector to the NEUTRAL position. Activate the control station. If the gear cannot be qualified, continue with this procedure.Test Step 1. ACTIVATE THE STATION AND DUPLICATE THE PROBLEM.
Turn the keyswitch ON.
Activate the suspect station.
Ensure that the diagnostic code is active. Expected Result:The diagnostic code is active.Results:
OK - The diagnostic code is active. Go to Test Step 2.
NOT OK - The diagnostic code is NOT active.STOPTest Step 2. CHECK ELECTRICAL CONNECTORS AND WIRING.
Turn the keyswitch OFF.
Inspect the wiring from the control station processor to the slim line control head or the side mount control head for the following conditions:
Abrasion
Corrosion
Incorrect attachment
Pinch points
Ensure that the following items are correctly mated and are in good condition: connectors, pins and sockets. Expected Result:All of the following are properly mated and in good condition: connectors, pins, and wires are properly mated and in good condition.Results:
OK - All connectors, pins, and wires are properly mated and in good condition. Go to Test Step 3.
NOT OK - All connectors, pins, and wires are NOT properly mated and in good condition.Repair: Repair the parts or replace the parts.After the repair, verify that the diagnostic code is NOT active.STOPTest Step 3. CHECK THE OPERATION OF THE SLIM LINE CONTROL HEAD OR THE SIDEMOUNT CONTROL HEAD.
Disconnect the cable between the control station processor and the slim line control head or the side mount control head.
Illustration 1 g01029957
Insert a 12-pin breakout T between the control station processor and the processor for the slim line control head or the side mount control head. Refer to Illustration 1.
Use a digital volt meter (DVM) in order to verify the operation of the slim line control head or the side mount control head. Refer to Table 1.
Table 1
Measure from Pin Measure to Pin Minimum(1) Maximum(2)
1 (+V ref) 3 (return) 4.75 VDC 5.25 VDC
2 (throttle) 3 (return) 0.6 VDC 5.00 VDC
(1) The minimum and maximum voltages will vary. This depends on where the throttle dead bands are set. The voltages should be the same for forward throttle and reverse throttle.
(2) The nominal voltage is 5.0 VDC.Expected Result:The voltages are within the limits that are listed in Table 1.Results:
OK