AVSPARE.COM
parts catalog

ENGINE AR- 5289049 - Caterpillar


5289049 ENGINE AR- Caterpillar parts
Rating:
11
Alternative (cross code) number:
CA5289049
528-9049
5289049
Caterpillar 5289049 ENGINE AR-

Buy ENGINE AR- 5289049 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:


Illustration 1 g01074026
Retract the extenders. You will need a 1220 mm (48 inch) straight edge. Use the height control to raise the extender above the main screed plate. Place the straight edge (4) on the outside edge of the main screed plate.
Use the height control to lower the extender until the trailing edge of the extender (1) touches the straight edge (4).
Move the straight edge to the opposite end of the extender. Use the slope control to adjust the extender until the trailing edge of the extender (1) touches the straight edge. The trailing edge of the extender should be parallel to the main screed plate.
Measure the gap (A) between the leading edge of the extender and the straight edge (4). The correct dimension for the gap is 3.175 mm (0.125 inch).
Illustration 2 g00707004
If dimension (A) is not correct, use the extender leveling adjusters to obtain the correct gap. Increase gap (A) by lowering the trailing edge of the extender. Decrease gap (A) by raising the trailing edge of the extender.
After adjusting the trailing edge of the screed plate, use the height control to raise the extender. Repeat steps 1 through 5. If the gap is now correct for the retracted extender proceed to step 7.
Place the straight edge along the outside edge of the main screed and extend the extender. Observe gap (A) as you extend the extender. If the gap varies, there could be a twist in the carriage extender tubes.
Illustration 3 g01074154
Relieve the twist in the carriage extender tubes by loosening the end bolts (5) and (6). This will allow the extender to relax. Tighten the bolts for the upper carriage extender tube (5) in a cross pattern. Tighten the bolts for the lower carriage extender tube (6) in a cross pattern. Repeat steps 1 through 7.


Parts engine Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.