ENGINE AR- 5586187 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
(A)     1P-0520     Bearing and Seal Driver     1    Note: Make sure that the bore in the stick and the bores in the link assembly are thoroughly clean and free of dirt. Make sure that the sleeve bearings and the lip type seals are thoroughly clean and free of dirt.
Illustration 1 g00607869
(Y) Sleeve bearing (Z) Stick
Lower the temperature of the sleeve bearing for the stick at the pin joint for the bucket control linkage. Use Tooling (A) and a hammer in order to install the sleeve bearing in the stick. Install the bearings so that dimension (c) is 5.5 0.8 mm (.22 .03 inch) below the outside surface of the stick.
Illustration 2 g00474169
Use Tooling (A) in order to install lip type seal (4) in the stick. Install the seal with the sealing lip toward the outside of the pin bore. Install the seal until the seal makes contact with the sleeve bearing.
Repeat Steps 1 and 2 in order to install the bearing and the seal on the opposite side of the stick.
Illustration 3 g00655739
(X) Bucket control linkage (Y) Bearing
Lower the temperature of the sleeve bearing for the closed end of the link assembly. Use Tooling (A) and a hammer in order to install the sleeve bearing in the link assembly. Install the bearing so that dimension (a) is 5.0 0.8 mm (.20 .03 inch) below the outside surface of the link assembly.
Illustration 4 g00605192
Use Tooling (A) and a hammer in order to install lip type seal (3) in the link assembly. Install the seal with the sealing lip toward the outside of the pin bore. Install the seal until the seal makes contact with the sleeve bearing.
Repeat Steps 4 and 5 in order to install the bearing and the seal in the opposite side of the link assembly.
Illustration 5 g00655749
(X) Bucket control linkage (Y) Sleeve bearing
Lower the temperature of the sleeve bearing for the open end of the link assembly. Use Tooling (A) and a hammer in order to install the bearing in the link assembly. Install the bearing so that dimension (b) is 5.825 0.8 mm (.2293 .0315 inch) below the outside surface of the link assembly.
Illustration 6 g00655904
Use Tooling (A) and a hammer in order to install lip type seals (1) on each side of the sleeve bearing. Install the seals with the sealing lip toward the outside of the pin bore. Install the seals until the seals make contact with the sleeve bearing.
Repeat Steps 7 and 8 in order to install the bearing and the seals in the opposite side of the link assembly.End By: Install the bucket control linkage. Refer to Disassembly and Assembly, "Bucket Linkage - Install" in this manual.