ENGINE & TRANSMISSION OIL COOLER 5P8959 - Caterpillar

Note: When any map recording is "ON", data is always transferred to the data card. Removal of the data card without stopping the map recording may cause the data to be corrupt.Map recording allows the system to record one of the following maps with an "ON/OFF" soft key:Coverage - Maps the number of passes made by a machineRadio Coverage - Maps the base radio statisticsTerrain - Maps the current elevationsCut/Fill - Maps the design "Cut/fill" values
When mapping is turned on, the position of the bucket is mapped. If the bucket is 0.7 m (2 ft) in the air then the mapped area will be 0.7 m (2 ft) in the air.
Map Recording Type Selection
Note: The contents of the "Setup Menu" dialog are site configurable. Depending on the "Operator Configuration" settings for your system, some of the options, soft keys, or views discussed in this manual may not be accessible. Refer to your site supervisor if a specific option is not available.By default, the map recording type is set to "None". A map recording type must be selected before the recording and the display feature can be used.Perform the following steps in order to access the "Map Recording" dialog.
From the "Setup Menu - Configuration" dialog, press the down arrow key or the up arrow key until "Map Recording" is highlighted.
Press the "OK" key. The "Map Recording" dialog is opened. This dialog is used in order to select a map recording type.Coverage Map Recording
Coverage map recording uses 1 x 1 m grid cells. The pass number for a cell is incremented each time the machine bucket passes over the cell. The number of passes over a cell determines the color of the cell on the plan view.Note: Elevation is not used in coverage map recording.Perform the following steps in order to set up the Coverage map recording.
Illustration 1 g01267661
Press the down arrow key or the up arrow key in order to highlight the "Coverage" map recording type. The "Map Recording" dialog appears. This is shown in Illustration 1.Use the "Required" field in order to specify the number of passes that are required. The default is 5 passes. The maximum number of passes that can be set is 20. The minimum number of passes that can be set is one.Table 1 shows the color code for the coverage map recording.
Table 1
Color     Passes to meet number required    
Gray     6    
Dark Gray     5    
Cyan     4    
Blue     3    
Red     2    
Yellow     1    
Green     0    
Press the "NEXT" key in order to highlight the "Required" field.
Press the down arrow key or the up arrow key in order to change the required number of passes. Green is always the final color indicating that the desired number of passes have been made.
Do one of the following.
Press the "OK" key in order to confirm the setting and in order to return to the "Setup Menu - Configuration" dialog.
Press the "ESC" key and