ENGINE AR 7N1515 - Caterpillar

Illustration 1. Dual winding vehicle speed sensor for 3406B (PEEC) Engines (not recommended).
Illustration 2. Single winding vehicle speed sensor for 3406B (PEEC) Engines (not recommended).
Illustration 3. Single winding vehicle speed sensor for 3406B (PEEC) Engines (recommended).
Illustration 4. Single winding vehicle speed sensor for 3176 Engines (recommended).For both engines, a single point ground connection at the speedometer is required for the vehicle speed buffer and the speedometer. Wiring the circuit in this manner reduces electrical noise to the PEEC or 3176 System. The 3406B (PEEC) Truck Engine Electrical Schematic 16 "PEEC Related OEM Truck System Response and Troubleshooting Guide," will be updated to show the recommended wiring and grounding procedures, as shown in Illustration 3. The 3176 Truck Engine Electrical Schematic, SENR3912-02 and 3176 Truck Engine OEM Systems Troubleshooting Guide, SENR4250, contain the recommended wiring and grounding for the vehicle speed circuitry, shown in Illustration 4.
Because electrical noise is hard to observe, it is difficult to diagnose these problems without the use of an oscilloscope. When problems arise with the vehicle speed circuit, follow these steps to reduce diagnosis and troubleshooting time.
1. Remove the vehicle speed sensor and inspect the sensor for damage or wear. Metal chips in the transmission can collect on the vehicle speed sensor and cause intermittent or erratic vehicle speed signals similar to those caused by a faulty connector. If the speed sensor has collected metallic debris, wipe the sensor clean and reinstall. This problem may occur again in the near future if the oil is contaminated. If the problem with the vehicle speed circuit persists, continue with Step 2.
2. If the speedometer is receiving its signal directly from a dual winding vehicle speed sensor (Illustration 1), disconnect the two wires from the sensor that go to the speedometer. If the speedometer is receiving its signal from the vehicle speed buffer (Illustrations 2 and 4), disconnect the two signal wires leading from the vehicle speed buffer to the speedometer. This step isolates the speedometer from the PEEC or 3176 System. Connect a DDT or ECAP to the P1/J1 connection and road test the truck to see if original conditions sill exist. If no fault code exist, continue with Step 3. If any fault codes are present, reconnect the speedometer to the speed buffer and follow the troubleshooting procedures in the 3406B (PEEC) Truck Engine Test Procedures Guide, SENR3479-02, or the 3176 Truck Engine Electronic Troubleshooting Guide, SENR3913-02.
3. To rewire a 3176 Engine, refer to Illustration 4 or the 3176 Truck Engine Electrical Schematic, SENR3912-02. To rewire a 3406B (PEEC) Engine, refer to Illustration 3, and follow these steps.3406B (PEEC) Engines
1. Remove the ground wire located in Pin B of Connector J13.2. Remove Wire E from Connector J13 (wire from negative lead on speedometer), and insert the wire into Location B of Connector J13.3. Insert Deutsch Connector Plug (8T8737) into Location E of Connector J13. Certain speedometers have an internal signal (-) to ground connection. If this internal connection is not present, an additional external wire