ENGINE AR 7W7013 - Caterpillar

Batteries
Illustration 7 g00289951
This warning label is located on the inside of the door for the battery compartment.
Improper jumper cable connections can cause explosion resulting in personal injury. Batteries may be located in separate compartments, always connect positive (+) cable to positive (+) terminal of battery connected to starter solenoid and negative (-) cable from external source to engine block or frame.
Battery
Illustration 8 g00289952
This warning label is located on the top of the batteries.
DANGER/POISONShield eyes, Explosive gases. Can cause blindness or injury.No sparks, flames or smoking.Sulfuric Acid can cause blindness or severe burns.FLUSH EYES IMMEDIATELY WITH WATER. Get medical help fast.Keep out of reach of children. Contains sulfuric acid. For medical emergency in USA or Canada contact: 800-458-5924, other countries contact:, 303-893-1322.
Brace the Lift Cylinder on Parallel Lift Machines
Illustration 9 g00289953
This warning label is located on the loader lift arm by the loader lift arm brace.
When performing any work underneath a raised loader lift arm, the loader lift arm brace must be in place. Install the loader lift arm brace as follows.
Empty loader bucket. Remove pin that secures loader lift arm brace to left loader arm. Raise loader arms to maximum height with the bucket in the dump position.
Position service brace over left lift cylinder with flat end against cylinder end.
Push pin through holes of loader lift arm brace and install cotter pin.
Slowly lower loader arms until brace contacts the top of the lift cylinder and bosses on loader arm.
To remove loader lift arm brace, reverse procedure.Failure to follow this procedure can result in death or serious injury if the loader arms are accidentally lowered.
Brace Lift Cylinder on Single Tilt Machines
Illustration 10 g00289954
This warning label is located on the loader lift arm by the loader lift arm brace.
When performing any work underneath a raised loader lift arm, the loader lift arm brace must be in place. Install the loader lift arm brace as follows.
Empty loader bucket, raise loader arms to maximum height with the bucket in the dump position.
Remove cotter pin from brace retaining pin and lower brace down over lift cylinder rod. Install retaining pin through lower holes of the service brace and install cotter pin in retaining pin.
Slowly lower loader arms until brace contacts the top of the lift cylinder and bosses on loader arm.
To remove loader lift arm brace, reverse procedure.Failure to follow this procedure can result in death or serious injury if the loader arms are accidentally lowered.
Extendable Stick
Illustration 11 g00289955
This warning label is located by the connectors for the auxiliary hydraulic hoses.
E-stick must be pinned before using attachments, to prevent movement which could cause personal injury.
Ether
Illustration 12 g00634757
This warning label is located on top of the storage compartment on the side console.
Do not spray ether into engine when using thermal starting aid to start engine. Personal injury and machine damage could result. Follow procedure in the Operation and Maintenance Manual.