ENGINE DRIVESHAFT GROUP 8I4714 - Caterpillar

Illustration 23 g00943527
Position cover (2) and install screws (3) .
Illustration 24 g00943525
Install screws (1). Install the cover on the front of the console.
Fill the hydraulic oil tank with clean hydraulic oil to the correct level. Refer to Operation and Maintenance Manual, "Hydraulic System Oil Level - Check" for the correct filling procedures. Refer to Operation and Maintenance Manual, "Lubricant Viscosities" for the proper oil viscosity.
Install the cap onto the hydraulic tank.Right Hand
Table 4
Required Tools    
Tool     Part Number     Part Description     Qty    
A     FT-1115     Vacuum Cap     1    
5P-0306 Vacuum Transducer     1    
6V-4142 Fitting     1    
5K-5068 Fitting     1    
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Illustration 25 g00975656
Position console (15). Install nut (14). Connect harness assemblies (12) and (13) .
Illustration 26 g00975653
Connect hose assemblies (11) onto pilot valve (10) .
Illustration 27 g00944947
Remove Tooling (A) .
Illustration 28 g00975652
Position console cover (8) and connect harness assembly (9) .
Illustration 29 g00975674
Install screws (7). Install a new cable strap (6) and install screws (5) .
Illustration 30 g00975650
Install knob (4) .
Illustration 31 g00975648
Position cover (2) and install five screws (3) .
Illustration 32 g00943525
Install screws (1). Install the cover on the front of the console.
Fill the hydraulic oil tank with clean hydraulic oil to the correct level. Refer to Operation and Maintenance Manual, "Hydraulic System Oil Level - Check" for the correct filling procedures. Refer to Operation and Maintenance Manual, "Lubricant Viscosities" for the proper oil viscosity.
Install the cap onto the hydraulic tank.