ENGINE AR 8N5809 - Caterpillar

Table 1
Diagnostic Trouble Codes for a high differential pressure for the air inlet system    
J1939 Code    CDL Code    Description
(Code descriptions may vary)    System Response    
107-15     E583(1)     High Air Inlet #1 Differential Pressure     The air filter differential pressure is above the trip point pressure for the delay time.
The code is logged.    
107-16     E583(2)     High Air Inlet #1 Differential Pressure     The air filter differential pressure is above the trip point pressure for the delay time.
The code is logged.
The engine power is derated.    
Table 2
Associated Diagnostic Trouble Codes    
J1939 Code     CDL Code    
107-3     582-3    Complete the procedure in the order in which the steps are listed.
Table 3
Troubleshooting Test Steps    Values    Results    
1. Check the Air Filter Element
A. Check the air intake system for plugged air filters or for damaged air filters. If the engine is equipped with an air intake precleaner, verify the proper operation of the air intake precleaner.
   
Plugged Air Filter
   
Result: The air filter is clogged.
Repair: Clean or replace the air filter. Verify that the problem is resolved.
Result: The air filter is not clogged.
Proceed to Test Step 2.
   
2. Check the Air Inlet Piping
A. Check the air inlet piping for damage or restrictions.
   
Damaged Air Inlet Piping
   
Result: The air inlet piping is damaged or has restrictions.
Repair: Repair the piping or replace the piping. Verify that the problem is resolved.
Result: The air inlet piping does not have damage or restrictions.
Proceed to Test Step 3.
   
3. Check the Atmospheric Pressure Sensor, Turbocharger Compressor Inlet Pressure Sensors, and/or Sensor Circuits
A. Use Cat ET to compare the value of the following parameters while the engine is off:
1. "Atmospheric Pressure"
2. "Turbocharger #1 Compressor Inlet Pressure (absolute)"
The value for air filter restriction is a calculated value. Before Cat ET reports the status parameters for air filter restriction, the engine must be running for 3 minutes. Cat ET will report "Conditions Not Met" for these parameters prior to this delay time.
   
Damaged Sensors
   
Result: The sensors and sensor circuits are OK.
Proceed to Test Step 4.
Result: The sensors and sensor circuits are not OK.
Repair: Repair or replace the sensors and/or sensor circuit. Verify that the problem is resolved.
   
4. Check the Enclosure Ventilation
A. Check that the engine has been installed in an enclosure that is sufficiently ventilated.
   
Enclosure Ventilation
   
Result: The engine does not have sufficient ventilation.
Repair: Repair the ventilation for the enclosure. Verify that the problem is resolved.