ENGINE AR 9Y1875 - Caterpillar

9Y1875 ENGINE AR Caterpillar parts 931C, D3C

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA9Y1875
9Y-1875
9Y1875

Weight: 3 pounds 1 kg.

Buy ENGINE AR 9Y1875 Caterpillar genuine, new aftermarket tractor parts with delivery
TRACK LOADER, TRACK-TYPE TRACTOR,

Compatible equipment models: 9Y1875:

TRACK LOADER 931C

TRACK-TYPE TRACTOR D3C Caterpillar

For full view, you need register

Information:

The correct procedures and tooling specifications must always be used. Failure to follow any of the procedures may result in damage, malfunction, or possible engine failure.
Illustration 1 g02981861
Rear view of engine
Illustration 2 g02981862
Right side view of engine
Table 1
Specification for 345-8994 Turbocharger Gp
Item Qty Part Specification Description
1 4 375-2467 Flange Locknut Use the following procedure in order to mount the turbocharger:
1. Loosen the nuts of compressor clamp assembly and band clamp enough to allow housing to rotate.
Excessive loosening of the housings will cause contact. Possible damage to the wheel may occur.
2. Before assembly, lubricate the threads and the bearing surfaces with Loctite C5A Copper Anti-Seize.
3. Mount the gasket (3) over the studs in the exhaust manifold.
4. Mount the turbocharger onto the exhaust manifold.
5. Tighten the flange locknuts to 70 5 N m (52 4 lb ft).
4 1 239-5858 Compressor Clamp Assembly Use the following procedure in order to tighten the compressor clamp and band clamp assembly:
1. Place the bearing housing (8) with the oil supply (6) and the oil drain (9) in the vertical position with respect to the engine as shown in the Illustration 2.
2. Position the compressor clamp (4) so that the threaded rod points downward on the outboard side of the turbocharger as shown in the Illustration 2.
3. Tighten the band clamp (5) on the 385-3580 Turbine Housing As (7) enough to prevent the bearing housing (8) from rotating.
4. Position the air outlet (2) of the compressor at 42 degrees (A) from the vertical (A). Position the air outlet (2) of the compressor on the side that is away from the engine as shown in the Illustration 1.
5. Tighten the compressor clamp (4) enough to prevent the compressor from rotating.
6. Tighten the nuts of both clamps to 13.6 1.2 N m (120.4 10.6 lb in).
7. Gently tap both clamps around the circumference of the clamps.
8. Again, tighten the nuts of both clamps to 13.6 1.2 N m (120.4 10.6 lb in).
5 1 361-7980 Band Clamp