ENGINE AR 9Y8862 - Caterpillar

Illustration 1 g00864299
The decal is located on the inside of the electronic door panel. The decal shows the locations of all of the electronic modules. (A) Location of the auto contour moduleWhen a new auto contour corn head is purchased, purchase an auto contour module for the combine. When an auto contour kit is installed on a corn head, purchase an auto contour module for the combine.After you install the new 209-9442 Auto Contour Module, adjust the sensitivity. The sensitivity should be set between 58 and 60. These settings are not the same settings for the small grain heads. These settings should only be used with the new corn head 209-9442 Auto Contour Module. The sensitivity adjustment ensures the proper time interval for the inputs on the head. This provides a good working operation. See Operation and Maintenance Manual, "Adjustment Auto Contour Sensitivity". This is necessary in order to fine tune the raise and lower adjustment of the head.