EXHAUST BRACKE 7R1573 - Caterpillar

To prevent possible personal injury do not make any adjustments to the control linkage with the engine running unless necessary and then let only approved personnel on the machine. Keep other personnel off the machine and in clear view of the service personnel.
Torque for all 3/8 in. locknuts (jam nuts) that hold the rod ends in place on the rod ... 14 4 N m (10 3 lb ft)Torque for all 1/2 in. locknuts (jam nuts) that hold the rod ends in place on the rod ... 45 7 N m (33 5 lb ft) All rod assembly measurements must be made in a straight line between the centerlines of the rod end mounting holes. All rods with 3/8 in. diameter threads must engage all rod ends a minimum of 14 mm (.55 in) of thread depth. All rods with 1/2 in. diameter threads must engage rod ends to a minimum of 19 mm (.75 in) of thread depth.(1) Dimension ... 64 mm (2.5 in)(4) Assembled length of spring ... 120.6 1.0 (4.75 .04 in)(8) Dimension ... 190.0 mm (7.48 in)(A) Assembled length of rod assembly ... 608 2 mm 23.94 .08 in)(B) Assembled lenght of rod assembly ... 540 2 mm (21.22 .08 in)(C) Assembled lenght of rod assembly ... 876 2 mm (34.49 .08 in)(D) Assembled lenght of rod assembly ... 536 2 mm (21.10 .08 in)(E) Assembled lenght of rod assembly ... 368 2 mm (14.49 .08 in)(F) Assembled lenght of rod assembly ... 192 2 mm (7.56 .08 in)(G) Assembled lenght of rod assembly ... 582 2 mm (22.91 .08 in)(H) Assembled lenght of rod assembly ... 172 2 mm (6.77 .08 in) Procedure for Adjustment of Steering Levers and Linkage
1. Disconnect rod assembly (B or D) from lever (6) at the steering control valve. Rod assembly (B) is for the left steering clutch and rod assembly (D) is for the right steering clutch.2. Adjust bumper (5) so that the centerline of steering clutch lever (2) is dimension (1) from the front of the operator console.3. Pull lever (6) toward the front of the vehicle until free movement stops (resistance is felt). Hold lever (6) in this position.4. Make an adjustment to rod assembly [(B)(left side)] and [(D)(right side)] to obtain a free fit of pin in lever (6).5. Perform Steps 1 through 4 for the other side.Procedure for Adjustment of Brake Pedal Linkage
1. Disconnect