EXTENSION-DRIVE SHAFT 1135581 - Caterpillar

Steering and Brakes
Illustration 12 g01257065
Steering and Brake Pressure Taps (23) Adjustment screws for the clutch pressure (24) Adjustment screws for the brake pressure (G) Left steering clutch (H) Left brake (J) Right steering clutch (K) Right brakeTransmission Control Linkage
Illustration 13 g00312215
Torque for all 5/8 inch jam nuts ... 38 2 N m (28 1 lb ft) (2) Torque for nut ... 18 3 N m (13 2 lb ft) (3) Rod assembly Length of rod assembly ... 202.0 1.5 mm (7.95 0.06 inch) Torque for 3/8 inch locknuts on rod assembly ... 12 4 N m (9 3 lb ft) (8,9) Torque for 1/4 inch locknuts on cable assemblies which hold the rod ends in place ... 8 5 N m (6 4 lb ft)Procedure to Adjust the Transmission Control Linkage
The transmission control linkage must be adjusted if transmission control lever (4) comes in contact with guide (5) in any position. Adjust direction control cable (9) in order to move transmission control lever (4) to either side. Adjust speed cable (8) in order to move transmission control lever (4) to the front or to the rear.
Remove bolts (11) that hold cover (10) in order to adjust either cable.
Loosen the locknut of the cable that needs to be adjusted. Turn cover (10) in order to adjust control lever (4). Turn cover (10) so that control lever (4) does not contact the guide in any position.Procedure to Adjust the Neutral Start Switch
Engage parking brake lever (7). The position is shown.
Adjust switch (6) until the roller is touching plate (1) .
Rotate switch (6) by another 3/4 of a turn. Then rotate the switch until the roller is aligned with plate (1) .Linkage for the Steering Clutch and Brake Controls
Illustration 14 g01239076
Steering clutch and brake control linkage adjustments should be made only with the engine OFF. Accidental disengagement of the parking brake while the engine is running could cause sudden machine movement and personal injury.
Torque for all 3/8 inch locknuts that hold the rod ends in place on the rod ... 14 4 N m (10 3 lb ft)Torque for all 1/2 inch locknuts that hold the rod ends in place on the rod ... 45 7 N m (33 5 lb ft)Note: All rod assembly measurements must be made in a straight line between the centerlines of the rod end mounting holes.Note: All of the 3/8 inch rods must engage the rod ends at a minimum depth of 14 mm (0.55 inch). All of the 1/2 inch rods must engage the rod ends at a minimum depth of 19 mm (0.75 inch). (1) Dimension ... 64 mm (2.52 inch) (4) Assembled length of rod assembly ... 120.6 1 mm (4.7480 0.04 inch) (8) Dimension ... 190 mm (7.48 inch) (A) Assembled length of rod assembly ... 815.0 1.5 mm (32.09 0.06 inch) (B) Assembled length of rod assembly ... 452.0 1.5 mm (17.79 0.06