EXTENSION GP-SCREED 1177804 - Caterpillar

Install spring guides (8) and springs (7) to the brake piston.
Use Tooling (A) and a suitable press to compress springs (7).
Install retaining pins (9) to spring guides (8), as shown.Note: Dip discs in lubricant to be used in brake compartment.Note: Follow Steps 9 through 12 for the assembly of the spindle assembly.
Illustration 7 g00523779
Illustration 8 g00523781
Apply clean oil to three brake discs (6). Install brake plates (5) and three brake discs (6) in the spindle assembly in alternating order. Start with a brake plate.
Illustration 9 g00524247
Illustration 10 g00523759
Align the teeth of three brake discs (6) and install hub (4) in spindle assembly (1).
Illustration 11 g00523756
Install retaining ring (3) in spindle assembly (1).
Illustration 12 g00523755
Install O-ring seal (2) in spindle assembly (1).Installation of the Service Brake Wear Indicator
Table 2
Required Tools
Tool Part Number Part Description Qty
B 4C-9507 loctitie 620 1 The service brake wear indicator must be installed into the correct location of the brake piston. If the service brake wear indicator was removed, use the following procedure tocorrectly install the service brake wear indicator.
Illustration 13 g01110882
Dowel locations. The current view shows the dowel in the "RF/LR" location.
Locate the correct position on the piston to install the service brake wear indicator. The piston housing has identification marks that indicate the placement of the indicator pin. The identification marks are "RF/LR" and "LF/RR". Install the indicator pin in the appropriate location."RF/LR" - The identification mark on the piston housing for installation in the right front service brake or installation in the left rear service brake."LF/RR" - The identification mark on the piston housing for installation in the left front service brake or installation in the right rear service brake.
Illustration 14 g01110841
Back Face of Piston
(1) Washer
(2) Indicator Pin
(3) Retaining Ring
(4) Identification Mark
Place washer (1) on head of the pin. Install retaining ring (3) to hold pin and washer to piston.
Apply Tooling (B) to the threads of the dowel.
Illustration 15 g00839046
End View of Axle Housing for the Service Brakes
Illustration 16 g01110928
Service Brake Wear Indicator
(5) Retaining Ring
(6) Washer
(7) Piston
(8) Piston housing
(9) Dowel
(10) Indicator Pin
(B) Visible length of the indicator pin
Thread the dowel into the piston housing until 6.7 0.25 mm (0.264 0.01 inch) of indicator pin (10) protrudes past dowel (9). See length (B) of Illustration 16 for reference. The amount of pin that is exposed is critical to correctly determine when the brake disc life has been exceeded.Note: The piston must be fully retracted into the piston housing to set the correct dowel length.End By:
Install the brake piston.