AVSPARE.COM
parts catalog

EXTENSION 1694295 - Caterpillar


1694295 EXTENSION Caterpillar parts G3508, G3512, G3516
Rating:
11
Alternative (cross code) number:
CA1694295
169-4295
1694295
Caterpillar 1694295 EXTENSION
Weight: 0.25 pounds 0 kg.

Buy EXTENSION 1694295 Caterpillar genuine, new aftermarket tractor parts with delivery
GAS ENGINE, GENERATOR SET,

Compare Prices: .

As an associate, we earn commssions on qualifying purchases through the links below
$209.10
 

13 Apr 2022

US: Components Depo
OEM Phoenix Contact 1694295, Connector, Universal, 4-Position for Sensor (1 Items)
Generic
$68.71
 

10 May 2021

US: IPA, Factory Wa
1694295 (2 Items)
Phoenix Contact
$186.35
 

10 May 2021

US: Amzn Sale
1694295, Connector, Universal, 4-Position for Sensor (5 Items)
Phoenix Contact
Number on catalog scheme: 6
  For full view, you need register

Compatible equipment models: 1694295:

GAS ENGINE  G3508   G3512   G3516  
GEN SET ENGINE  G3508   G3512   G3516  
GENERATOR SET  G3508   G3512   G3516   Caterpillar

Information:


Illustration 1 g01413528
Connections of the second gear solenoidThis diagnostic code is associated with the second gear solenoid. The FMI 05 code means that the ECM has determined that the current is below normal.The possible causes of this diagnostic code are listed below:
The solenoid energizer circuit of the modulating valve is open.
The return circuit of the modulating valve is open.
The solenoid has failed.
The ECM has failed. This is unlikely.Before performing this procedure, inspect the harness connectors that are involved in the circuit. Poor connections can often be the cause of a problem in an electrical circuit. Verify that all of the connections in the circuit are clean and secure. If a problem with a connection is found, correct the problem and verify that this diagnostic code is active before performing this procedure.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 1404 FMI 05 is active before performing this procedure.Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.System Response:When this diagnostic code is active, the ECM will turn off the current to the failed solenoid.Test Step 1. CHECK THE SOLENOID
Turn the disconnect switch and the starter keyswitch to the ON position. Do not start the engine.
Disconnect the solenoid with the active diagnostic code from the transmission harness.
At the connector of the transmission harness for the solenoid, place a jumper wire from contact 1 (wire 900-PU) to contact 2 (wire 975-WH).
Observe the status of the CID 1404 FMI 05 code.Expected Result:The CID 1404 FMI 05 code remains active. The FMI has not changed and the 05code is still active.Results:
YES - The diagnostic code remains active. The jumper wire does not affect the diagnostic code. Proceed to Test Step 2.
NO - The diagnostic is no longer active. The solenoid has failed.Repair: The solenoid has failed. Repeat this Test Step "CHECK THE SOLENOID" in order to verify the solenoid failure. Replace the solenoid. Verify that the new solenoid corrects the problem.STOPTest Step 2. CHECK THE HARNESS FOR AN OPEN
Turn the starter keyswitch and the disconnect switch to the OFF position.
Disconnect the connectors of the transmission harness from the ECM.
The jumper wire that was installed in the previous test remains in place.
At the connector of the transmission harness, measure the resistance from signal contact J1-49 (wire 900-PU) to contact J1-50 (wire 975-WH).
At the connector of the transmission harness, measure the resistance from signal contact J1-49 (wire 900-PU) to contact J1-50 (wire 975-WH).Expected Result:Both resistances are less than 5.0 ohms.Results:
OK - Both resistances are less than 5.0 ohms. The transmission harness is correct. Proceed to Test Step 3.
NOT OK - Either resistance is greater than 5000 ohms. The resistance measurement is not correct. There is an open circuit in the transmission harness.Repair: The open is in wire 900-PU or in wire 975-WH of the transmission harness. Repair the transmission harness or replace the transmission harness.STOPTest Step 3.

Caterpillar parts catalog:

Caterpillar parts catalog
G3516 Engine Electronic Ignition System 4EK00001-UP
G3516 Engine Electronic Ignition System 8LD00001-UP
G3512 ENGINE 7NJ00001-UP
G3508 Engine Electronic Ignition System 9TG00001-UP
G3512 Gas Engine Electronic Ignition System 5JD00001-UP
G3508 Standard Engine Electronic Ignition System 4WD00001-UP
G3508 ENGINE 9AW00001-UP
G3512 ENGINE 6JW00001-UP
G3516 Chiller Engine 8PW00001-UP
G3512 TANDEM ENGINE 7SZ00001-UP
G3532 Generator Set Engine 8BZ00001-UP
G3508 Engine 2TJ00001-UP
G3516 Generator Set CSZ00001-UP
G3516 Generator Set CPG00001-UP
G3508 Generator Set CPY00001-UP
G3512 Generator Set CSP00001-UP
G3508 Generator Set CPJ00001-UP
G3512 Generator Set CRN00001-UP
G3508 Generator Set CPS00001-UP
G3516 Generator Set ZAZ00001-UP
G3516 Generator Set ZBA00001-UP
G3508 Engine DLR00001-UP
G3512 Engine GNS00001-UP
G3516 Engine WPS00001-UP
G3516 Gas Generator Set E6N00001-UP
G3516 Gas Generator Set E6Y00001-UP
G3516 Generator Set L6A00001-UP
G3516 Generator Set L6E00001-UP
G3516 Generator Set L6F00001-UP
G3516 Generator Set L6G00001-UP


Parts extension Caterpillar catalog:

3F6166 EXTENSION
14E, 235, 245, 245B, 245D, 312D, 3508, 3508B, 3508C, 3512, 3516, 3516B, 611, 613, 615C, 844K, 906H, 906H2, 907H, 907H2, 908H, 908H2, 914G, 928G, 928H, 928HZ, 943, 950, 953, 966C, 988K, 990K, D10T2, G3...
1U7118 EXTENSION
3126, 3304, 3304B, 3306, 3306B, 3406, 3406C, 3406E, 3408E, 3412, 3412C, 3412E, 3508, 3508B, 3512, 3512B, 3516, 3516B, 589, 910G, 924F, 938F, 938G, 950F, 950F II, 950G, 962G, 963, 963B, 973, D5B, D6D, ...
1U7119 EXTENSION
307C, 311C, 312, 3126, 313B, 3304, 3304B, 3306, 3306B, 3406, 3406C, 3406E, 3408E, 3412, 3412C, 3412E, 350, 3508, 3508B, 3512, 3512B, 3516, 3516B, 589, 938G, 950G, 962G, D6D, D8R II, G3304, G3512, G351...
9Y7042 EXTENSION AS
G3508, G3512, G3516
1234710 EXTENSION AS
G3508, G3512, G3516
1599926 EXTENSION AS
3508, 3508B, 3512, 3512B
1298803 EXTENSION-PLUG
G3408, G3408C, G3412, G3412C
2137445 EXTENSION-PLUG
G3408, G3408C, G3412, G3412C
1999013 EXTENSION
G3516B, G3520B, PMG3516
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.