EXTENSION 1H3214 - Caterpillar

1. Remove the plate assembly from the right side of the engine compartment. 2. Use tool (A) to remove oil filter (3) from the oil filter base.3. Remove two bolts (2) and oil filter base (1) from the engine. 4. Remove plug (8), spring (6) and valve (5) from oil filter base (1).5. Remove O-ring seal (7) from plug (8).6. If necessary, remove stud (4) from the oil filter base. The following steps are for installation of the oil filter and base.7. If stud (4) was removed from the oil filter base, put 9S3263 Thread Lock on the threaded end that is to be installed in the oil filter base.8. Install stud (4) in the oil filter base. Tighten the stud to a torque of 68 7 N m (50 5 lb ft).9. Install O-ring seal (7) on plug (8).10. Install valve (5), spring (6) and plug (8) in oil filter base (1) as shown.11. Make sure the O-ring seal is in position on the oil filter base. Put oil filter base (1) in position on the engine, and install two bolts (2).12. Install oil filter (3). Follow the instructions on the filter. See the Maintenance Manual for correct service intervals.