EXTENSION (L.H.) 2D8730 - Caterpillar

2D8730 EXTENSION (L.H.) Caterpillar parts 140B, 14E

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA2D8730
2D-8730
2D8730

Weight: 106 pounds 48 kg.

Buy EXTENSION (L.H.) 2D8730 Caterpillar genuine, new aftermarket tractor parts with delivery
MOTOR GRADER,

Compatible equipment models: 2D8730:

MOTOR GRADER 140B 14E Caterpillar

Number on catalog scheme: None

Caterpillar 2D8730 Parts scheme EXTENSION (L.H.)

For full view, you need register

Information:

Illustration 1 g03335361
This diagnostic code is recorded when the Implement ECM stops receiving information on the CAN data link.Note: The resistance of the data link circuit should measure approximately 120 ohms between the components.Test Step 1. INSPECT THE HARNESS CONNECTIONS
Turn the disconnect switch to the OFF position.
Inspect all harness connections that are related to the CAN data link. Make sure that the connectors are clean and tight.
Check the connectors for proper mating. Ensure that all the seals are present and in place.
Check the harness for signs of damage or abrasion.
Check the wires at the connector. Ensure that the wires are secured tightly into the connector. Take care not to pull the wire out of the connector.
Check the exposed wires at the connectors for nicks or signs of abrasion.
Check for moisture inside the connector.
Check the connectors for dirty or corroded contacts.
Check each pin and socket of the machine harness connectors. Ensure that the contacts are properly installed. The contacts should mate correctly when the two pieces of the connector are placed together.Expected Result:The machine harness connectors are tight and free of corrosion.Results:
OK - The machine harness connectors are tight and free of corrosion. Proceed to Test Step 2.
NOT OK - The machine harness connectors are in need of repair.Repair: Repair or replace