EXTENSION GP-SCREED 4875627 - Caterpillar

Illustration 1 g01957776
Typical example (1) Tires (2) Lug nutsDo not change the size of the tires. Do not change the type of the tires. Tighten all lug nuts to the proper specification.Refer to the OEM "Operators Manual" for more information on the trailer for operation and maintenance.
Observe all local traffic regulations and observe federal traffic regulations involved in towing the trailer package for lawful operation.
Failure to utilize an appropriate and properly sized tow vehicle that has a level horizontal hitch connection could lead to excessive towing sway. This could result in personal injury or death.
The weight of the tow vehicle should be equal to or greater than the total weight of the package. The total weight of the trailer package is marked on the front of the unit. Verify that the tow vehicle is rated for towing the gross vehicle weight before you attempt to tow the package.The following illustrations are for a trailer with a tongue and a hitch. Your trailer may be different from the following illustrations.
Before towing, inspect the coupling devices and check the torque on the tongue retaining bolts.Required torque is 370 50 N m (273 37 lb ft).
Illustration 2 g01957777
Typical example (1) Jack (2) Towing eye (3) HitchThe adjustable trailer hitch should be mounted at the same height as the hitch on the tow vehicle. This will reduce the tendency for vertical pressure to be applied on the hitch.
Illustration 3 g01957778
Typical example (1) Tongue (2) Breakaway switch (3) Breakaway cable (4) 7-Pin Connector (5) Tow vehicle (6) Security chain (7) Towing eye and hitch (8) Breakaway battery and battery chargerA breakaway cable is attached to an electric brake switch that is on the tongue of the trailer. If the trailer is accidentally unfastened during towing and the pin on the end of the breakaway cable is pulled out of the breakaway switch, the brakes for the trailer are actuated. Attach the breakaway cable to the tow vehicle.
If the breakaway switch is actuated, the actuator bracket will require replacement. The breakaway switch should only be used in emergency situations.
Inspect the security chains. Inspect the breakaway cable. Inspect the coupling device of the tow vehicle and the chain attachment points. Look for the following defects:
excessive wear or corrosion
components that are cracked, components that are deformed, or components that are degraded
loose nuts, bolts, or other fasteners
DO NOT allow any personnel between hitch or vehicle and trailer. Failure to comply could cause possible crushing injuries or death.
Ensure that no one is in the way. The tow vehicle should then be backed up to the trailer. Position the tow vehicle in preparation for coupling.Position the tow vehicle with sufficient clearance behind the vehicle for hooking up to the trailer package.Do not attempt to raise or lower the tongue of the trailer by hand. Use the jack that is provided.
Keep hands and fingers clear of the coupling device and all other pinch points. Keep feet clear of the trailer tongue to avoid injury in case the trailer tongue should slip