EXTERNAL MAST 1137958 - Caterpillar

Two-Way Flow Direction With One Pump Flow (System 5)
Table 3
Programming parameters that are available for machines that are equipped with Two-Way Flow Direction With One Pump Flow (1)    
Parameter Number     Default Value With 2 Pumps
"Tool #1 - Tool #5"    
001     "AUX TOOL #1 - #5"    
002     10    
003     ON    
004     ENABLED    
005     ENABLED    
101     NA    
102     NA    
103     NA    
( 1 ) This configuration is referred to as "CONFIG 5" on the Electrical System Schematic, RENR5526.Note: On System 5 Two-Way / One Pump machines, the parameters are never reprogrammed. Reprogramming the values does not have any effect on the performance of the machine.One-Way / Two-Way Flow Direction With Two Pump Flow, Plus Auxiliary Valve (System 11 Prime)
Table 4
Programming parameters that are available for machines that are equipped with One Way / Two-Way Flow Direction With One Pump / Two Pump Flow (1)    
Parameter Number     Default Value With 1 Pump
"Tool #1"
    Default Value With 2 Pumps
"Tool #2 - Tool #5"    
001     "AUX TOOL #1"     "AUX TOOL #2 - #5"    
002     10     10    
003     ON     ON    
004     ENABLED     ENABLED    
005     DISABLED     ENABLED    
101     95.0     95.0    
102     0     0    
103    
17000 kPa (2465 psi)    
17000 kPa (2465 psi)    
( 1 ) This configuration is referred to as "CONFIG 11 Prime" on the Electrical System Schematic, RENR5526.Programming The Five Tools
In order to program any of the parameters of the machine, you must first enter Service Mode on the monitor. This procedure is described in full in Testing and Adjusting, "Service Mode - Enter". Immediately after you enter the password for the service mode, the following screen will be on the monitor:
Illustration 1 g00777652
The keys of the monitor are called out in the following illustration:
Illustration 2 g00685772
Monitor Panel (7) Up key (8) Left key (9) Right key (10) Down key (11) Cancel key (12) Menu key (13) OK key (14) keyUse the down key (10) in order to highlight line 2. Use the right key (9) and scroll until "CONFIGURATION" is on the display. If you press the right key again, "TOOL PROGRAM" is on the display. Under these two headings, you will program all of the parameters of the machine. The parameters that are available for programming are shown in the following illustration:
Illustration 3 g00779002
Illustration 4 g00779463
After you reach the "TOOL PROGRAM" screen, press the down key (10) in order to highlight the third line. The left side of the line ("TOOL#1") is initially highlighted. This is shown in illustration 4. Press the left key (8) or the right key (9) in order to scroll through the five tools that are available. After you reach the desired tool, press the menu key (13) in order to highlight the right side of the line. This is shown