F N/R LEVER 1039459 - Caterpillar

Personal injury or death can result from improperly checking for a leak.Always use a board or cardboard when checking for a leak. Escaping air or fluid under pressure, even a pin-hole size leak, can penetrate body tissue causing serious injury, and possible death.If fluid is injected into your skin, it must be treated immediately by a doctor familiar with this type of injury.
Illustration 1 g00104545
Prevent the machine from movement. Park the machine on a level surface.Attach a "Do Not Operate" warning tag to the start switch before you service or repair the equipment. These warning tags (Special Instruction, SEHS7332) are available from your Caterpillar dealer.Required Parts
Table 1
467-4022 Front Lines Gp Revision - 00    
Item    Qty    Part No    Description    
(1)     1     7K-1181     Cable Strap    
(2)     1     148-8430     Tee As    
(3)     1     338-6971     Pressure Sensor Gp    
(4)     1     459-5870     Hose As    
(5)     1     153-6237     Elbow As    
(6)     4     5P-5148     Cable Strap    
Illustration 2 g03723878
467-4022 Front Lines Gp Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Note: Put identification marks on all hoses, hose assemblies, harness assemblies, and on all tube assemblies for installation purposes. Plug all hose assemblies and all tube assemblies. Plugging hoses and tubes helps to prevent fluid loss, and helps to keep contaminants from entering the system.
Illustration 3 g03723879
(1) 7K-1181 Cable Strap (2) 148-8430 Tee As (3) 338-6971 Pressure Sensor Gp (4) 459-5870 Hose As (5) 153-6237 Elbow As (6) 5P-5148 Cable Strap
Install hose at port "bL4" on main control valve.
Route hose to boom.
Unless specified, tighten all hardware and fittings to standard torque.ReferenceTorque Specifications, SENR3130, "Torque Specifications"
Illustration 4 g00687600
Personal injury or death can result from escaping fluid under pressure.Escaping fluid under pressure, even a very small pin-hole size leak, can penetrate body tissue, causing serious injury, and possible death.Always use a board or cardboard when checking for a leak.Do not check for pin hole leaks in pump or motor hoses during a steer stall condition. If fluid is injected into your skin, it must be treated by a doctor familiar with this type of injury immediately.
Inspect for fluid leaks when the installation is complete.