FAN AS 1270622 - Caterpillar

Removal Procedure
Start By:
Connect the steering frame lock.
Release the pressure in the hydraulic tank.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Note: The steering metering pump is located beneath the front of the cab.
Illustration 1 g00407063
Typical example.
Remove five bolts (2) and panel (1) from each side of the machine.
Illustration 2 g00407062
Typical example.
Illustration 3 g00407061
Typical example.
Disconnect five hose assemblies (5) .
Remove four bolts (4) .
Remove steering metering pump (3) .Installation Procedure
Install steering metering pump (3) in the reverse order of removal.