FAN 3594817 - Caterpillar

3594817 FAN Caterpillar parts C4.4

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA3594817
359-4817
3594817

Weight: 5 pounds 2 kg.

Buy FAN 3594817 Caterpillar genuine, new aftermarket tractor parts with delivery
INDUSTRIAL ENGINE,

Compatible equipment models: 3594817:

INDUSTRIAL ENGINE C4.4 Caterpillar

Number on catalog scheme: 1

For full view, you need register

Information:

Illustration 1 g00292989
Open left engine access door (1) .
Illustration 2 g00292990
Illustration 3 g00292993
Disconnect ground cable (3) from alternator (2) .
Disconnect two harness connectors (4) and (6) .
Remove harness clip (5) .
Illustration 4 g00292994
Remove two nuts (7), guard (8) and the spacers.
Illustration 5 g00292996
Loosen two adjusting nuts (9) in order to relieve the tension on bolt (10). Back off the inside adjusting nut by 38 mm (1.5 inch).
Remove belt (10) from alternator pulley (11) .
Illustration 6 g00292995
Remove bolt (12) in order to disconnect tension rod (14) from the alternator.
Remove pivot bolt (13) and alternator (2). The weight of the alternator is 14 kg (30 lb).
Remove the nut and the washer from the alternator. Use a suitable puller and remove the drive pulley.Installation Procedure
Illustration 7 g00292990
Install the drive pulley, the nut and the washer on alternator (2). Tighten the retaining nut for the drive pulley to a torque of 110 10 N m (81 7 lb ft).
Illustration 8 g00292995
Install alternator (2) and pivot bolt (13). The weight of the alternator is 14 kg (30 lb).
Connect tension rod (14) to the alternator and install bolt (12) .
Illustration 9 g00292996
Install belt (10) on alternator pulley (11) .
Adjust the tension of the alternator belt.Note: Check the belt tension. Use a Kent-Moore Co.BT-33-109. The correct tension for a new alternator belt is 800 22 N (180 5 lb). The correct tension for a used alternator belt is 490 44 N (110 10 lb).
Tighten two adjusting nuts (9) and (10) .
Illustration 10 g00292994
Install the spacers, guard (8) and two nuts (7) .
Illustration 11 g00292993
Install harness clip (5) .
Connect two harness connectors (4) and (6). The torque for the output terminal nut is 7.1 0.8 N m (63 7 lb in). The torque for the ground terminal nut is 6.2 0.6 N m (55 5 lb in).
Connect ground cable (3) to alternator (2) .
Illustration 12 g00292989
Close left engine access door (1) .End By: Separate the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".