FAN 3602827 - Caterpillar

Illustration 1 g00515083 (1) Diameter of camshaft journal ... 173.80 0.03 mm (6.843 0.001 inch)Bore in camshaft bearing after installation ... 174.00 0.05 mm (6.850 0.002 inch) (2) Thickness of new plate ... 11.80 0.05 mm (0.465 0.002 inch) (3) Timing bolt location
Illustration 2 g00289768
Location of dowels on the camshaft bearing journal
Illustration 3 g00469453
Location of dowels on the camshaft bearing journal
Correct cam segment relationship (timing) must be observed at assembly. If the cam segments are out of time, serious engine damage will occur.
Note: The position of the single dowel in relation to the variable dowel determines the letter designation of the cam journals. The single dowel is located on the same end as the locating groove. The variable dowel is located on the end opposite the locating groove. (5) Locating groove (6) Location of the single dowel in the face of the camshaft bearing journal Distance from the top of the dowel to the camshaft bearing journal ... 7.0 0.5 mm (0.28 0.02 inch) (7) Location of the variable dowel in the face of the camshaft bearing journal Distance from the top of the dowel to the camshaft bearing journal ... 7.0 0.5 mm (0.28 0.02 inch)
Illustration 4 g00289771
Letter designation of 3606 camshaft journals
Illustration 5 g00469407
Letter designation of 3608 camshaft journals
(8) Camshaft bearing journal Install the camshaft bearing journals with the grooved end toward the front of the engine. (9) Camshaft segments Install the camshaft segments with the grooved flange toward the rear of the engine for standard rotation engines. Install the camshaft segments with the grooved flange toward the front of the engine for reverse rotation engines. (10) Tighten the bolts for the camshaft segment to the following torque. ... 270 40 N m (200 30 lb ft) (11) The camshaft must be assembled in an assembly fixture or the camshaft must be assembled in the cylinder block. Apply a force at the rear end of the camshaft (11). The rolling torque for the 3606 must be a maximum of the following value. ... 22 N m (16 lb ft)Apply a force at the rear end of the camshaft (11). The rolling torque for the 3608 must be a maximum of the following value. ... 28 N m (21 lb ft)
Illustration 6 g00289772 (12) Specified camshaft lobe lift To find the specified camshaft lobe lift, use the procedure that follows:
Measure the total height of the camshaft (13).
Measure base circle (14).
Subtract base circle (14) from the total height of camshaft (13). The difference is the specified camshaft lobe lift (12).
Specified camshaft lobe lift (12) for the camshaft is the following value: Exhaust lobe ... 19.500 mm (0.7677 inch)Inlet lobe ... 19.500 mm (0.7677 inch)Lobe for fuel injection pump ... 21.473 mm (0.8454 inch)