FAN GP-SUCTION 4171353 - Caterpillar

Illustration 7 g03378993
Illustration 8 g03379014
Ensure that the appropriate controller is selected, either Joystick or Powertrain, and then click the "OK" button. The Configuration window is opened and the support tool is now ready for use.COM Port and Interface Settings
To connect to a controller during the support tool session:
The computer must be set to use the appropriate serial interface for those using the USB to RS232/485 adapter.
The support tool must be set to communicate using the appropriate COM port.Serial Interface Setting
When using a USB to RS232/485 adapter the driver must be set correctly to interface with the serial interface in use. To either verify this or change it perform the following procedure.Note: Ensure that the adapter driver is installed.
Connect the USB to RS232/485 adapter to the computer's USB port and the controller's communications harness to the adapter's RS232/485 port.
Illustration 9 g03379018
To verify or change the current interface settings, click on the Utilities/Communication/Change MOXA UPort interface.
Illustration 10 g03379023
A pop-up window opens. Follow the instructions to change the adapter type. When you click "OK" as instructed, the Device Manager window opens
Illustration 11 g03379025
Follow the instructions to change the adapter type. When you click "OK" as instructed, the Device Manager window opens.
Illustration 12 g03379048
As instructed, double-click "UPort 1150". The "UPort 1150" Properties window opens.
Illustration 13 g03379068
Click Port Settings. The Port window opens. Set the com port number and the appropriate interface type for the adapter.
Click "OK". The computer is now configured for the adapter's serial interface and com port.Com Port Setting
Illustration 14 g03379078
Click the "COM#, xxxx Baud" button in the lower right corner of the support tool screen or click the "Utilities/Communications/Settings" menu item.The Communications Setting window opens.
Illustration 15 g03379081
Select the appropriate COM port for the RS232 or RS485 connection being used.
Click "OK". The support tool is now set to use the selected com port.Connecting to a Controller
In order to perform Field Modify, Field Setup, Diagnostics, and System Tune a connection with the controller must be established. The following sections provide information for connecting to a control.Field Modify, Field Setup and Diagnostics
When an attempt is made to perform Field Modify, Field Setup and Diagnostics without first establishing a connection to the controller, the following message is displayed:
Illustration 16 g03379086
To connect to a controller for the Field Modify, Field Setup or Diagnostics function, perform the following procedure:
Connect the appropriate communication harness and any required adaptors between the laptop computer and J4 (for RS232) or J10 (for RS485) of the control.
Launch and log into the support tool as described in "Launching the Support Tool".
Select the appropriate COM port for the support tool as described in the "COM Port and Interface Settings".
Power-up or cycle power on the control. The support tool status changes to indicate a connection to the controller has been established.
Illustration 17 g03379087
Enter Field Modify, Field Setup, or Diagnostics as required from the screen.