FAST PLATE 0899092 - Caterpillar

Illustration 1 g06183993
Right Console
(1) Display
(2) Water spray enable switch
(3) Propel lever
(4) Green indicatorPropel lever (3) and display (1) are on the right console. Water spray enable switch (2) is on the propel lever (optional propel lever shown). The water spray switch controls the on and off status of the water spray system.Note: The standard propel lever has two switches that control the vibratory and water spray system. The left switch on this propel lever is the water spray enable switch. The water input to the water control logic is the same when the machine is equipped with either propel lever.Propel lever (3) communicates with the machine ECM through the CAN.Water spray enable switch (2) is momentary and operates only when the engine start switch is in the ON position. Each time the operator presses the water spray enable switch, an input signal is sent to the machine ECM. The machine ECM toggles the status of the water system between off and on with each input signal. Green indicator (4) on the left side of display (1) indicates that the system is on. The machine ECM illuminates this indicator.If water spray enable switch (2) is held for more than 2 seconds, water will continuously spray. After the water spray enable switch is released, the water timer will return to the previously set water spray percentage.
Illustration 2 g06183995
Right Console
(5) Water spray timer increase switch
(6) Water spray timer decrease switch
(7) Water spray mode switchThe keypad is on the right console. The keypad contains the following water system switches:
Water spray timer increase switch (5)
Water spray timer decrease switch (6)
Water spray mode switch (7)Each of the switches provides an input signal to the machine ECM through the CAN. The machine ECM uses the input from these switches to determine the desired operating conditions for the water system.The switches on the keypad operate the water spray system. Water spray mode switch (7) toggles between pump"1", pump"2", or automatic modes. Automatic mode is selected by pressing and holding the water spray mode switch for 2 seconds. The water spray timer switches allow adjustment of the water spray interval.The indicators next to water spray mode switch (7) illuminate the currently selected water spray mode. When viewed from the operator perspective, the bottom indicator is illuminated when the system is in pump"1" mode. The middle indicator is illuminated when the system is in pump"2" mode. The top indicator is illuminated when the water spray mode is switched to automatic.The water spray mode will also be shown on display (1) every time water spray mode switch (7) is pushed. The pop-up display will disappear after three seconds. Five seconds after the last switch was pushed the operational state will be saved into memory. This operational state will be retained after a key cycle.When the water spray system is operating in the automatic mode, the system will automatically stop when propel lever (3) is moved into the NEUTRAL position. When the propel lever is moved into the forward range, the number-two