FASTENER GP-WIRING HARNESS 2595295 - Caterpillar

src="//c1.a2109.com/cat2/se/sehs/sehs9681b00007.png"> To mount the 4P-8767 Differential Pressure Switch, four holes with a diameter of 4.8mm (.19 in) will need to be put in the EMTB back face. The 4P-9481 Mounting Bracket can be used as a template for hole placement.The 7W-1380 Terminal Strip should be mounted on the EMTB back face beside the pressure switch. Four holes with a diameter of 4.8mm (.19 in) will need to put in the back face. The terminal stripe can be used as a template for hole placement.The 6I-4938 Fitting mounts in the EMTB bottom face. A 9.0mm (0.35 in) diameter hole will have to be put in the bottom face to accommodate the fitting.The 4P-8767 Differential Pressure Switch is a three contact switch. One contact is the common contact, one is for normally open (N.O.) contact position and the other is for the normally closed (N.C.) contact position. The switch should be wired according to the application that it is being used in.Seal Holes In EMTB Bottom Face
Using the hardware that is provided, seal all the holes in the bottom face of the EMTB that are not being used.Reassembly
Reassemble the top face cover and the grounding strap to the EMTB. A hole 4.3mm (.17 in) will have to be added to the EMTB front "C" channel for routing of the ground strap.Before installing the filter elements spray a thin layer (1.5 - 2 oz) of light machine oil on the filter elements. Allow any excess oil to drain from the filter elements before installing in the generator.Reassemble the side panels and mount the filter assembly to the EMTB front face.Filter Maintenance
Remove the filter elements. Soak the filter elements in hot water and detergent. Rinse the filter elements and recharge with a thin layer of light weight machine oil before reinstalling.800 Frame Generator Sets
The following procedure gives step by step instructions for the installation of the air filter assembly kit hardware.Installation Procedure For 800 Frame Generator
Remove the side panels, top cover, grounding strap, and louver assembly to provide access to the EMTB frame assembly (see illustration 1).
Illustration 1 (EMTB frame assembly with covers removed).Front Face Installation Procedure
Cut the foam sealing strips for the front face to the following lengths: Mounting surfaces must be free of all dirt, oil and foreign material before foam sealing strips are installed. Each foam