FELT 2R1009 - Caterpillar

Move Forward
The machine heading and drum orientation differ by 180 degrees.Probable Causes
The positioning algorithm has determined that the machine is reversing.Problem Isolation
Move forward approximately 2 m (7 ft).No Alignment Selected
No alignment is selected.Probable Causes
There is no alignment selected.Problem Isolation
Select an alignment for horizontal guidance.No Controls Data
No automatic controls information is being received.Probable Causes
There is a cable fault between the display and one or more of the control devices.
One or more of the control devices is not responding.Problem Isolation
View the "Diagnostics" screen in order to check that all devices are responding.
Check the cable connections of any device that is not responding.No Design Loaded
There is no design loaded into the Display.Probable Causes
There is no design loaded.
The previously-loaded design is no longer present on the CompactFlash data card.
The CompactFlash data card was removed while the design file was being loaded.Problem Isolation
Note: Do not remove the CompactFlash card while the design data is being loaded.
Ensure that a design is selected and loaded.
Verify that the desired design is present on the CompactFlash card.Off Design
The configured vertical guidance points are outside the area covered by the design. There is no design visible and no cut/fill information provided.Probable Causes
The machine is working near the edge of the design. The machine has moved beyond the limits of the design.Problem Isolation
Operate the machine within the boundaries of the design.
Ensure that the boundaries of the design are established so that the machine remains on the design.