FENDER AS 1497437 - Caterpillar

Illustration 1 g00537188
Install pin (76) to two valve bodies (E) and (G). Install plug (75) and the O-ring seal to two valve bodies (E) and (G) .
Illustration 2 g00537187
Install plug (74) and the O-ring seal to two valve bodies (A) and (F) .
Illustration 3 g00537185
Install four stops (73) and four dowels (72) to selector pressure control valve (55). Install seven slugs (71) and seven springs (70) to selector pressure control valve (55) .
Install retainer ring (69), the retainer, spring (68), ball (67), and spool (66) to the seven ports in the selector pressure control valve (55) .
Install stop (65), inner spring (64), and outer spring (63) to the seven ports in selector pressure control valve (55) .
Install piston (62), piston (61), shims (60), and spacer (59) to each valve body. Install two plugs (58) and the O-ring seals to each valve body (54) .
Install the O-ring seal, cascade orifice (57), and spring (56) to each valve.
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Position seven valve bodies (54) to selector pressure control valve (55) .
Install 14 bolts (53) and the washers that secure valves (A), (B), (C), (E), (F), (G), and (H) to the selector pressure control valve.
Install two plugs (52) and the O-ring seals to the selector pressure control valve.
Illustration 4 g00526788
Install pipe plug (51) .
Install stop (50), dowel (49), spring (48), and spacers (47). Install ball (46), the spring, the slug, and the ring to spool assembly (45). Install two pipe plugs (44) and spool assembly (45) .
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Install the two dowels to spring support assembly (43). Position spring support assembly (43) to the selector pressure control valve. Install two bolts (42) and the washers that secure spring support assembly (43) to the selector pressure control valve. Tighten the two bolts to a torque of 30 7 N m (22 5 lb ft).
Install the seal O-ring and O-ring (41) to detent cam (37). Install two pins (40) to detent cam (37). Locate the slot in the inner pin. Position the slot in the outer pin so that the slot is perpendicular to the inner pin's slot. Install spool assembly (9), pin (39), and dowel (38) to detent cam (37) .
Install detent cam (37) to the selector pressure control valve. Install bolt (36) and the washer. Tighten the bolt to a torque of 30 7 N m (22 5 lb ft). Install two needle bearings (35) to the spring assemblies. Install two spring assemblies (34) and two bearing retainers. Install the spring assemblies with the snap rings facing out from the valve body. Install pin (33) and the retaining ring. Install two retainers (32) and the two bolts to the spring support assembly. Loosen the two bolts and two retainers (32). Center the roller of the spring assemblies in the