FENDER 3716228 - Caterpillar

Illustration 3 g00523107
Remove shim pack (3).
Illustration 4 g00523108
Install Tooling (A) and a suitable lifting device to wheel assembly (4), as shown. The weight of wheel assembly (4) is approximately 127 kg (280 lb).
Remove wheel assembly (4) from spindle assembly (5).
Illustration 5 g00523283
Remove bearing cone (6) and Duo-Cone seal (7) from spindle (5). Bearing cone (6) is a slip fit to spindle (5).
Use the following procedure to install Tooling (B) in the hole of hub (8):
Illustration 6 g00523302
Place a suitable lifting device in the hole of hub (8).
Illustration 7 g00523329
Install the bolt between the suitable lifting device and the hole.
Illustration 8 g00523332
Fasten the suitable lifting device to the bolt by tying the suitable lifting device around the bolt, as shown. This will prevent the bolt from moving during the removal of hub (8).
Illustration 9 g00523334
Repeat Steps 7.a through 7.c in order to install Tooling (B) in the two remaining holes.
Attach a suitable lifting device to the lifting slings. The weight of hub (8) and ring gear (9) as a unit is approximately 68 kg (150 lb). Remove hub (8) and ring gear (9) from wheel assembly (4).
Illustration 10 g00523362
Remove Duo-Cone seal (10) from wheel assembly (4).
Illustration 11 g00523365
Illustration 12 g00523393
Remove bearing cups (11) and (12) from wheel assembly (4).
Illustration 13 g00523408
Remove bolts (13) and the washers from hub (8).
Illustration 14 g00523432
Remove retaining ring (14) from ring gear (9).
Illustration 15 g00523441
Use a suitable lifting device to remove hub (8) from ring gear (9). The weight of the hub (8) is approximately 32 kg (70 lb).
Illustration 16 g00523444
Remove bearing cone (15) from hub (8).
Illustration 17 g00523445
Remove bushing (16) from hub (8).