FENDER AS 3728054 - Caterpillar

Illustration 61 g03471182
Assembled
(17) 345-6078 Knob As
(18) 345-6146 Louver Cover
(24) 359-1585 Cover As
Place Louver Cover (18) onto the front opening of the Cab Liner and secure with two Knobs (17). Hand-tighten the Knobs until the Knobs contact the Cab Liner, and then tighten the Knobs one more turn. Install Cover As (24) to the side of the Cab Blower. Insert the tabs on the Cover into the slots on the side Plate of the Cab Blower. Slide the Cover down to engage onto the Plate and rotate the latch on the Cover clockwise to hold closed. Refer to Illustrations 60 and 61.
Illustration 62 g03471219
(7) 258-3795 Seal
(20) 345-6192 Duct As
Illustration 63 g03471220
Assembled
(7) 258-3795 Seal
(20) 345-6192 Duct As
Install one Seal (7) to the bottom opening on the right-hand side of Duct As. (20). Peel the protective paper from the Seal and install the adhesive side onto the Duct As. Refer to Illustrations 62 and 63.Note: Repeat for the left-hand side 345-6191 Duct As (19)
Illustration 64 g03471222
( 5) 146-6371 Louver As
(20) 345-6192 Duct As
Illustration 65 g03471223
Assembled
(5) 146-6371 Louver As
(20) 345-6192 Duct As
Install three Louver As. (5) to each of the openings on the right-hand side Duct As. (20). Refer to Illustrations 64 and 65.Note: Repeat for the left-hand side 345-6191 Duct As (19)
Illustration 66 g03471224
( 20) 345-6192 Duct As
(26) 388-7876 Bracket As
(46) 9X-2045 Screw
Illustration 67 g03471226
Assembled
(20) 345-6192 Duct As
(26) 388-7876 Bracket As
(46) 9X-2045 Screw
Install Bracket As. (26) to the right-hand side of Duct As. (20) on the location shown in Illustrations 66 and 67. Use two Screws (46) to secure the Bracket. Ensure that the nut on the Bracket is facing the right-hand side of the Machine.Note: Repeat for the left-hand side 345-6191 Duct As (19)
Illustration 68 g03471229
Illustration 69 g03471637
Assembled (view from the front)
(20) 345-6192 Duct As
(46) 9X-2045 Screw
Install Duct As. (20) onto the right-hand side opening on the bottom of the Cab. Insert the Bracket between the frame of the Canopy and the right-hand side Post Cover. Align the holes on the Canopy and on the Bracket, as shown in Illustrations 68 and 69. Attach the Duct As. onto the front frame of the Canopy by inserting one Screw (46) from the right-hand side of the Duct As.Note: Repeat for the left-hand side 345-6191 Duct As (19)Note: Lower the Lift arms to the operating position.Note: Verify that the heating system is working correctly. Check for any leaks in the system.