FENDER AS 4802238 - Caterpillar

before any operation or any maintenance procedures are performed.The user is responsible for the performance of maintenance. All adjustments, the use of proper lubricants, fluids, filters, and the replacement of components due to normal wear and aging are included. Failure to adhere to proper maintenance intervals and procedures may result in diminished performance of the product and/or accelerated wear of components.Use mileage, fuel consumption, service hours, or calendar time, WHICH EVER OCCURS FIRST, in order to determine the maintenance intervals. Products that operate in severe operating conditions may require more frequent maintenance. Refer to the maintenance procedure for any other exceptions that may change the maintenance intervals.Note: Before each consecutive interval is performed, all maintenance from the previous interval must be performed.Note: If Cat HYDO Advanced hydraulic oils are used, the hydraulic oil change interval may be extended substantially. S O S services may extend the oil change even longer. Consult your Cat dealer for details.When Required
Additive Spray System - Drain
Battery - Recycle
Battery or Battery Cable - Inspect/Replace
Engine Air Filter Primary Element - Clean/Replace
Engine Air Filter Secondary Element - Replace
Film (Product Identification) - Clean
Fuel System - Prime
Fuses - Replace
Oil Filter - Inspect
Radiator Core - Clean
Water Spray Nozzles - Clean
Water Spray System - Drain
Wheel Nuts - Tighten
Every 10 Service Hours or Daily
Backup Alarm - Test
Cooling System Coolant Level - Check
Drum Scrapers - Inspect/Adjust/Replace
Engine Air Filter Service Indicator - Inspect
Engine Oil Level - Check
Hydraulic System Oil Level - Check
Neutral Start Switch - Test
Operator Presence Switch - Test
Seat Belt - Inspect
Tire Scraper - Inspect/Adjust/Replace
Water Spray System Filter - Clean
Initial 50 Service Hours
Wheel Nuts - Tighten
Every 50 Service Hours or 2 Weeks
Tire Inflation - Check
Every 100 Service Hours or 2 Weeks
Fuel Tank Water and Sediment - Drain
Water Tank Strainer - Clean and Inspect
Every 250 Service Hours
Engine Oil Sample - Obtain
Every 250 Service Hours or 3 Months
Articulating and Oscillating Bearings - Lubricate
Belts - Inspect/Adjust/Replace
Steering Cylinder Ends - Lubricate
Initial 500 Hours (for New Systems, Refilled Systems, and Converted Systems)
Cooling System Coolant Sample (Level 2) - Obtain
Every 500 Service Hours
Fuel Tank Strainer - Clean
Every 500 Service Hours or 3 Months
Cooling System Coolant Sample (Level 1) - Obtain
Every 500 Service Hours or 1 Year
Braking System - Test
Engine Oil and Filter - Change
Hydraulic System Oil Filter - Replace
Hydraulic System Oil Sample - Obtain
Isolation Mounts - Inspect
Every 1000 Service Hours or 1 Year
Battery - Clean/Check
Cooling System Pressure Cap - Clean/Replace
Engine Mounts - Inspect
Engine Valve Lash - Check
Hydraulic Tank Breather - Replace
Hydraulic Tank Strainer - Clean
Rollover Protective Structure (ROPS) - Inspect
Every Year
Cooling System Coolant Sample (Level 2) - Obtain
Every 3000 Service Hours
Engine Water Pump - Inspect
Every 3000 Service Hours or 18 Months
Hydraulic System Oil - Change
Every 3 Years
Seat Belt - Replace
Every 6000 Service Hours or 3 Years
Cooling System Coolant Extender (ELC) - Add
Every 12 000 Service Hours or 6 Years
Cooling System Coolant (ELC) - Change