FENDER & MOUNTING GP 8X9982 - Caterpillar

start by:a) separation of governor from governor drive 1. Remove locknut (2) and loosen bolt (1) one complete turn. 2. Put the governor drive on wooden blocks. Use a brass punch and hammer to hit (tap) bolt (1) to loosen gear (3) from shaft (5).3. Install a 5/16"-18 NC jam nut on bolt (4) even with the end of bolt (4). Use a brass punch and hammer to loosen the bolt from the lever.4. Remove bolt (1), washer, jam nut and bolt (4).5. Remove gear (3) and shaft (5). 6. Remove lever and shaft assembly (7), lever (8) and shaft (6). 7. Inspect bearing (9) for wear and damage. If a replacement is needed, use tooling (A) to remove it.8. Inspect seal (10) for wear and damage. If a replacement is needed, the seal must be destroyed to be removed.9. Inspect bearings (11) for wear and damage. If replacements are needed, use tooling (A) to remove these.Assemble Governor Drive
1. If bearing (2) was removed, make an alignment of the oil holes in the bearing and housing (1). Use tooling (A) to install bearing (2) even with the face of housing (1). 2. If bearing (3) was removed, install the bearing with tooling (A) approximately 0.30 in. (7.6 mm) above the face of housing (1).3. If bearing (4) was removed, install the bearing with tooling (A) even with the bottom of the seal counterbore.4. Install seal (5), with the lips of the seal toward the inside, with tooling (A) to the bottom of the seal counterbore. Put a small amount of engine oil on the lip of seal (5). 5. Put shaft (6) and lever (9) in position in housing (1).6. Put lever and shaft assembly (8) in position in housing (1) through lever (9). Make sure the end of lever (9) is engaged in the groove of shaft (6).
Before dowel (7) is installed make sure the end of shaft (8) does not make contact with the inner face of bearing (3). If the end of shaft (8) makes contact with the inner face of bearing (3), move the bearing away from the end of the shaft.
7. Install dowel (7) that holds shaft (8) in place.8. Fasten lever (9) to shaft (8) with the taper bolt and locknut. 9. Put shaft (11) in position in housing (1).10. Install gear (10) on shaft (11).end by:a) connection of governor to governor drive