FILLER 1U2050 - Caterpillar

START BY:a) remove steering clutch hubsb) remove steering clutch control valve 1. Remove two bolts (1) and lockwashers. Remove plate (2) and tube (3). 2. Remove two bolts (8) lockwashers and clips (5). Remove two bolt (4) and lockwashers and remove bracket assembly (6) and tubes (7). 3. Remove six bolts (9) and lockwashers. 4. Fasten a hoist to the bevel gear shaft. Use a hoist as a support for the shaft. Install two 3/8"-16 NC forcing screws (11) in cage (10). Remove the cage and shims. Put identification on the shims for correct assembly. 5. Remove ten nuts (13) and bolts and five locks. Remove ring gear (12) from the shaft. Remove the ring gear from the bevel gear case. 6. Remove shaft assembly (14) from the bevel gear case. 7. Remove bearing cup (15) from the cage as shown. 8. Install tooling (A) on shaft assembly (14) as shown. Remove bearing cones (16).Install Bevel Gear and Shaft
1. Lower the temperature of bearing cup (1) and install in cage (2). The bearing cup must make contact with the bottom of the bearing counterbore in the cage. 2. Heat bearing cone assemblies (4) to a maximum temperature of 275°F (135°C). Install the bearing cone assemblies on shaft (3). The bearing cone assemblies must make contact with the shoulder on the shaft. 3. Put the shaft assembly in position in the bevel gear case. 4. Install ring gear (5) on the shaft with ten bolts, nuts and five locks. Tighten two of the nuts 180° apart to 200 20 lb.ft. (270 25 N m). Then tighten the remainder of the nuts to 200 20 lb.ft. (270 25 N m). If the original thickness of shims is not known, or if a replacement is made of some part of the bevel gear and shaft group, see Bevel Gear and Pinion Shaft Settings.5. Fasten a hoist as a support for the shaft and ring gear assembly. Install correct shims (6) and cage assembly (2) with six bolts and lockwashers. 6. Inspect and make a replacement if necessary of the O-ring seal on tube (8). Put 7M7260 Liquid Gasket Material on the surfaces where tube assembly and the bevel gear case make contact. Install the tube assembly and plate (7) with two bolts and lockwashers. 7. Install two tubes (11) with two clips, bolts (10) and lockwashers. Install bracket assemblies (9) with two bolts and lockwashers. Put tubes (11) into holes in the bracket assembly.END BY:a) install steering clutch hubsb) install steering clutch control valve