FILLER AS 4T0984 - Caterpillar

Illustration 27 g02616351
Press down key (12) until "Service" is highlighted on the display screen.
Press OK key (13) .
Illustration 28 g02616353
Press down key (12) until "Calibrations" is highlighted on the display screen.
Press OK key (13) .
Illustration 29 g02616355
Press down key (12) until "Right Auger" is highlighted on the display screen.
Press OK key (13) .
Illustration 30 g02616357
Press OK key (13) to begin the calibration.
Illustration 31 g02616359
Illustration 32 g02616360
Move right auger switch (14) to the AUTO position.
Illustration 33 g02616361
Squeeze trigger (15), and move propel lever (1) to the FORWARD position.
Press OK key (13) .
Illustration 34 g02616364
Illustration 35 g02616365
Right Screed Operator Station on AS2302C Screed
Illustration 36 g02616366
Right Screed Operator Station on AS3301C Screed
Illustration 37 g02616368
Rotate right material height dial (16), on the screed, to the MINIMUM position.
Press OK key (13) .
Illustration 38 g02616370
Rotate right material height dial (16) clockwise until the right auger just begins to operate.
Press OK key (13) .
Illustration 39 g02616372
Rotate right material height dial (16) clockwise until the speed of the right auger shaft reaches 150 10 rpm. Use Tool (A) to measure the speed.
Press OK key (13) .
Illustration 40 g02616375
The display should now read "CALIBRATION COMPLETE". Push back key (17) to return to calibration screen.
Push home key (11) to exit the calibration screen.
Move propel lever (1) to the NEUTRAL position.
Move right auger switch (14) to the OFF position.
Move throttle control switch (8) to the LOW IDLE position. Hold the switch in this position for less than 1 second.
After the engine reaches low idle, move engine start switch (9) to the OFF position.