FILM-IDENTIFICATION 1273330 - Caterpillar

The UPS functions automatically in order to supply AC electrical power to the critical load. There are several operation modes that allow the UPS to accomplish this task. Most of the operating modes have several states that occur in that mode. The mode and the state are displayed on the LCD display. The LCD display is located on the front panel. The operating modes are listed below:
On-line Modes
Bypass Modes
Automatic Voltage Regulation ModeThe UPS continually monitors internal systems and the incoming utility power. The UPS will automatically change between the modes, as required. This is accomplished with no intervention by an operator. The detection logic and the switching logic inside the UPS ensures that the changes in the operating mode are automatic and transparent to the critical load.On-line Modes
Illustration 1 g00989862
On-line Mode"Online" - The "Online" mode is the standard operating mode for the system. When the system is in this mode, the load is protected. The system is capable of discharging in order to support the load."Online Charging" - The system enters this state when the flywheel reaches 4000 RPM. The system is charging in this state. The system can sustain discharge in this state."Online Standby" - When the speed of the flywheel reaches 7700 RPM, the system is in the "Online standby" state. This is rated idle speed for the flywheel.
Illustration 2 g00989976
On-line DischargingOn-line Discharging - The system is in this state when the unit is supplying power to the load. If there is a disruption in power, the system will change to this state.Bypass Modes
Illustration 3 g00990003
Bypass ModeBypass - Bypass mode directly connects the incoming utility to the system load. When the system is in the bypass mode, the load is not protected. The load can be affected by a disruption of incoming power.The Bypass mode is entered by one of the following events:
Start-up
The Keyswitch (Manual)
Failure to Recover From a FaultRepeated errors that cause the system to oscillate between the bypass mode and On-line mode can lock the system into the bypass mode. When the system is locked in the bypass mode, the user must change the mode of the system. Use the keyswitch in order to change the mode of the system.Bypassed-Verify Signals - When the system is in this state, the system verifies that the correct system telemetry is present. This state is used when you are starting the system and the state is used during the recovery of errors.Bypassed Auto Start - This is the default state at start-up. The system cannot immediately protect the load after the system is started. The system will enter