FILM-MONITOR 1307495 - Caterpillar

Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g00543616
Typical example
Inspect the condition of the gasket. Replace the gasket, if necessary.
Ensure that the rocker arm for the fuel transfer pump is not under pressure.
Install the gasket and fuel transfer pump (2). If fuel transfer pump (2) is difficult to install, rotate the crankshaft.
Install two lock plates (4) .
Install four bolts (3). Tighten the bolts to a torque of 22 N m (16 lb ft).
Connect two fuel lines (1) .
Loosen the vent screw on the top of the fuel filter and operate the priming lever on the fuel transfer pump in order to remove the air from the fuel system. When only fuel comes out of the vent screw, tighten the vent screw.
Start the engine and check the fuel system for fuel leaks and for air leaks.