FILM-STRIPE 1400097 - Caterpillar

Illustration 1 g00885222
(1) Use shims to adjust the lateral clearance. Adjustment for clearance ... 1 - 2 mm (0.04 - 0.08 inch) 093-0090 Shim ... 1 mm (0.04 inch) 7Y-3355 Shim ... 1.6 mm (0.06 inch) 093-0122 Shim ... 2 mm (0.08 inch)Note: All bores must be free of paint. Coat all bores for pins with lubricant. (2) 205-4668 Pin Diameter after plating ... 99.85 .04 mm (3.931 0.002 inch) Minimum thickness for plating ... 0.005 mm (0.0002 inch)Note: Make sure that the bearings are installed in the bore so that the identification numbers of the bearings are facing outward. (3) Two 186-5465 Sleeve Bearings Outside diameter ... 116.155 .011 mm (4.5730 0.0004 inch) Inside diameter ... 100.290 .020 mm (3.9484 0.0008 inch) Installation depth for the bearing in the bearing bore ... 9.5 .8 mm (0.37 0.03 inch) (4) Lubricate the sealing lip slightly with the lubricant that is being sealed. Install the dust seal so that the lip faces to the outside. Refer to the detail. Install the seal so that the seal does not extend beyond the face of the boss. (5) Two 137-2819 Sleeve Bearings Outside diameter ... 106.200 .013 mm (4.1811 .0005 inch) Inside diameter ... 90.270 + .087 - .000 mm (3.554 + .003 - .000 inch) Installation depth for the bearing in the bearing bore ... 9.5 .8 mm (0.37 0.03 inch)