FILM-INFORMATION 2522157 - Caterpillar

Illustration 6 g00597430
Position flood lamp (28) for installation. Install two bolts (27) (not shown) and the washers.
Connect wiring harness (26) at the electrical connection.
Repeat Step 9 and Step 10 for the remaining flood lamp.
Illustration 7 g00597429
Attach a suitable sling to guard assembly (24). Attach the other end of the suitable lifting sling to a hoist. Position the guard assembly for installation.
Install four bolts (25), the washers, and the mounts.
Illustration 8 g00597428
Connect wiring harness (22) at the electrical connection.
Install new tie strap (23) .
Illustration 9 g00597427
Connect hose assembly (20) and hose assembly (21) .
Illustration 10 g00597425
Connect hose assembly (17), hose assembly (18), and hose assembly (19) .
Illustration 11 g00597423
Connect hose assembly (13), hose assembly (14), hose assembly (15), and hose assembly (16) .
Illustration 12 g00597422
Connect hose assembly (12) .
Install tube assembly (11) and the manifold as a unit.Note: The manifold is on the bottom of the tube assembly. The manifold is not shown.
Illustration 13 g00597419
Connect hose assembly (10) .
Illustration 14 g00597418
Position bracket (9) for installation. Install two bolts (8) and the washers.
Connect hose assembly (6) and hose assembly (7) .
Illustration 15 g00597414
Connect hose assembly (4) and hose assembly (5) .
Illustration 16 g00597413
Install two bolts (3) and the washers.
Illustration 17 g00597412
Connect hose assembly (2) .
Illustration 18 g00587678
Install drain plug (1) and the O-ring seal. Tighten the drain plug to a torque of 68 7 N m (50 5 lb ft).
Refill the hydraulic tank. Refer to Operation and Maintenance Manual, "Hydraulic System Oil Level - Check" for the correct procedure to fill the hydraulic tank. The capacity of the hydraulic tank is 723 L (191 US gal).
Illustration 19 g00597410
Remove the suitable stands that are under the arm and bearing assembly.End By:
Remove the wheel chocks. Refer to Disassembly and Assembly, "Wheel Chock (Front and Rear) - Remove and Install".
Disconnect the frame lock link. Refer to Disassembly and Assembly, "Frame Lock Link - Separate and Connect".
Start the engine and check the level of the hydraulic tank. Refer to Disassembly and Assembly, "Hydraulic System - Pressure Release / Charge".