FILM-LFT CAP 3063610 - Caterpillar

Illustration 14 g01515951
The configuration that is shown applies to 994K, 992K, and 854K machines. The 263-7745 Control Harness As is used on these machines. (6) 293-3533 Plate As (Left) (7) 306-0310 Plate As (Right) (19) Monitor Harness As
Locate the Display Bracket As (8) (or (6) and (7) ) at the right front side of the cab.
Illustration 15 g01516005
(20) 291-2199 Monitor Display Gp (21) Monitor Harness As
Connect the Monitor Harness As (21) to the 291-2199 Monitor Display Gp (20) .
Locate the parts in Table 4. These parts can be found in the machine CAES ARO group.
Table 4
Parts required to mount the operator display    
Qty     Part Number     Description    
4     4M-5282     Bolt (1/4-20)    
4     9X-6165     Washer    
8     8C-5607     Isolation Mount    
4     8C-5608     Spacer    
Illustration 16 g01515991
The exploded view for mounting the operator display is shown. (22) 291-2199 Monitor Display Gp (23) Display Bracket As (24) 8C-5607 Isolation Mount (25) 8C-5608 Spacer (26) 9X-6165 Washer (27) 4M-5282 Bolt
Attach the 291-2199 Monitor Display Gp to the Display Bracket As. Use the parts in Table 4. Refer to Illustration 16 during the installation.Note: Tighten the bolts to Caterpillar standard torque specifications.Dimension Measurements and Measure Up
Illustration 17 g01196187
METSmanager screen shot of machine dimensions
You must enter correct details. Any errors transfer directly into the finished surface.
Measure the machine GPS Receiver offsets referenced to the machine's specific dimensions for setting the machine up in the office from METSmanager.ReferenceRefer to the sample METSmanager screen shot, Illustration 17, as a reference guide and template in order to record the machine dimensions. Note: The "X" measurement that is taken to the right of the centerline of the machine will be a positive number. The "X" measurement that is taken to the left of the centerline of the machine will be a negative number. Note: The "Y" measurement that is taken in front of the front axle will be a positive number. The "Y" measurement that is taken behind the front axle will be a negative number.
GPS x: Measure the distance from the center of the GPS Receiver (10) to the centerline of the machine.
GPS y: Measure the distance from the center of the GPS Receiver (10) to the center of the front axle of the machine.
Illustration 18 g01516031
(10) 291-1913 GPS Receiver (28) Top of lower housing
GPS z: Measure the distance from the top of the lower housing (28) of the GPS Receiver (10) to the bottom of the wheels.
Bucket Width: Measure the width of the machine from the outside edges of the bucket.
Wheelbase: Measure the distance from the center of the front axle to the center of the rear axle.
Maximum Reach: Measure the distance from the center of the front axle to the front