FILM-IDENTIFICATION 3440864 - Caterpillar

3440864 FILM-IDENTIFICATION Caterpillar parts 329E, 329E L, 329E LN

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA3440864
344-0864
3440864

Weight: 0.03 pounds 0 kg.

Buy FILM-IDENTIFICATION 3440864 Caterpillar genuine, new aftermarket tractor parts with delivery
EXCAVATOR,

Compatible equipment models: 3440864:

EXCAVATOR 329E 329E L 329E LN Caterpillar

Number on catalog scheme: 45

Caterpillar 3440864 Parts scheme FILM-IDENTIFICATION

For full view, you need register

Information:

Table 1
J1939 Code and Description CDL Code and Description Comments
5584-15
Engine Fuel Filter Degradation : High - least severe (1) E390 (1)
Fuel Filter Restriction The code is logged.
The filter is becoming clogged. Change the filter at the next regular maintenance.
5584-16
Engine Fuel Filter Degradation : High - moderate severity (2) E390 (2)
Fuel Filter Restriction The code is logged.
The difference between the filtered fuel pressure and the unfiltered fuel pressure is greater than the trip point pressure.
The engine ECM will derate engine power.
Change the fuel filter. Probable Causes
Fuel Filter
Fuel filterNote: Change the primary filter, the secondary filter, and the tertiary filter at the same time. Use clean fuel on the stud threads of filter base to reduce friction.Note: Do not fill the canister or the fuel filter before installation. The fuel can carry debris into the fuel filter and the fuel system may be damaged. The electric priming pump is designed to purge the trapped air in the new filters.
Table 2
Troubleshooting Test Steps Values Results
1. Change the Fuel Filters
A. Reset all active codes and clear all logged codes by cycling the keyswitch to the Off position. Change the primary fuel filter.
B. Prime the system with the electric priming pump.
C. Start the engine and allow the engine to idle for few minutes.
D. Turn the engine OFF and change the secondary fuel filter.
E. Prime the system with the electric priming pump.
F. Start the engine and allow the engine to idle for few minutes.
G. Turn the engine OFF and change the tertiary fuel filter.
H. Prime the system with the electric priming pump.
J. Restart the engine.
Fuel Filters
Result: The code is no longer active
Result: The event code becomes active after changing the fuel filters.
Repair: The problem may be electrical. Refer to Troubleshooting, "Sensor Signal (Analog, Active) - Test" for the procedure to troubleshoot the circuit.
If the procedure did not correct the issue, contact your Cat dealer Technical Communicator (TC). For further assistance, your TC can confer with the Dealer Solutions Network (DSN).