FILM-IDENTIFICATION 3935325 - Caterpillar

Removal Procedure
Start By:
Remove the right side engine guard.
Failure to follow established procedures can lead to damage of the parts.To avoid damage to the parts, always identify and mark the parts so that the parts can be installed in the same location.
Note: Ensure that all main surfaces are clean and free of debris.Note: Refer to Special Instruction, REHS1728, "Application Guideline for the Bellows" for additional information on handling the bellows if the machine is equipped.
Illustration 1 g02190414
Remove clamps (1) , (3) , and (4) . Remove elbow (2) .
Illustration 2 g02190436
Disconnect hose assembly (5) .
Illustration 3 g02190437
Disconnect tube assembly (6) .
Illustration 4 g02190440
Remove bolts (7) . Reposition tube assembly (8) .
Illustration 5 g02190453
Disconnect tube assemblies (9) and reposition out of the way.
Illustration 6 g02190493
Remove clamps (10) and (11) . Discard clamp (11) .
Illustration 7 g02190533
Illustration 8 g02194733
Remove nuts (12) .
Use a suitable lifting device in order to remove turbocharger (13) . The weight of turbocharger (13) is approximately 36 kg (80 lb).Installation Procedure
Ensure the flange connection for the turbocharger to air filter intake is clean and free of debris. Proper alignment and use of a new clamp is necessary to ensure a leak free joint".Note: Check all of the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
Install turbocharger (13) in reverse order of the removal.