FILM-IDENTIFICATION 4258034 - Caterpillar

Note: A New specification is the performance that can be expected for a new machine. Performance beyond the Service Limit is an indication of these problems: improper maintenance or adjustment, component wear, and failure.
Table 2
Corresponding Engine RPM and Torque Output for Each Engine Speed Dial Position (No Load Condition)
Engine Speed Dial Position High Hydraulic Power Mode Standard Mode Economy Mode
Engine RPM Torque Output (%) Engine RPM Torque Output (%) Engine RPM Torque Output (%)
1 900 20.0 900 20.0 900 20.0
2 1000 33.0 1000 33.0 1000 33.0
3 1150 46.0 1150 46.0 1150 46.0
4 1260 60.0 1260 60.0 1260 60.0
5 1360 76.0 1320 73.0 1320 69.0
6 1450 87.0 1380 85.0 1380 74.0
7 1530 94.0 1440 94.0 1440 78.0
8 1600 97.0 1490 98.0 1490 80.0
9 1680 99.0 1550 102.0 1550 82.0
10 1750 100.0 1600 105.0 1600 85.0 Introduction
The following test is used to measure engine speed at the flywheel housing.Required Tools
Illustration 1 g02535237
Tooling (C)
Table 3
Tooling Item QTY Part
Number Description
C 348-5430 Multi-Tool Gp
C1 1 285-0908 Multi-Tool
C2 1 6V-2198 Cable As
C3 1 9U-5140 Photo Pickup
C4 1 6V-3137 Base
C5 1 1U-6605 Reflective Tape
C6 1 6V-3138 Extension Reference: Refer to Tool Operating Manual, NEHS1087 for operating instructions for the 348-5430 Multi-Tool Gp.Note: Use Software License Card, NETG5049 with part number 348-5430 Multi-Tool Gp.Machine Preparation
Position the machine on level ground.
Stop the engine.
Install tooling (C) on the engine.Test Procedure
Start the engine.
Increase the hydraulic oil temperature to 55° 5°C (131° 9°F).
Read the engine speed display (rpm) on the multi-tool. Refer to Table 1 for the specifications for engine speed at the desired engine operation.