FILM-CAT BR318 4745427 - Caterpillar

2. Put gear (28) in position in the flywheel. Make an alignment of the splines in the gear with the splines in friction discs (27).3. Put plate (24), spring (25) and retainer (26) in place in the flywheel housing. Install three of the bolts (22) loosely to hold the assembly in position.4. Put tooling (A) in position in gear (28) and the flywheel housing. Tooling (A) will put the discs and plate in a center position.5. Install the bolts that hold the assembly in place. Tighten the bolts to a torque of 56 7 N m (42 5 lb ft). Remove the gear and tooling (A). 6. Install gear (28) on the shaft. Install the plate and the two bolts that hold the gear on the shaft.7. Install a 1/2" - 13 NC forged eyebolt in the top of the retarder housing and attach a hoist. 8. Install two 7/16" - 14 guide bolts (29), 127 mm (5.0 in.) long as shown, and lift the housing into position and slide it on the guide bolts and onto the studs.9. Lift the housing into position and slide it onto the studs. Slowly, turn the engine to make an alignment of gear (28) and the friction discs. Install the nuts and bolts that hold the housing in position. 10. Slide drive shaft (5) in and make an alignment of the external splines on the drive shaft with the internal splines of the shaft in the retarder housing. 11. Put tooling (B) in position in the bore of housing (10) to check alignment of the engine with the drive shaft. Make a rotation of tooling (B) in bore around the drive shaft until resistance is felt in both the clockwise and counterclockwise directions.12. Find the center of free movement (travel) of tooling (B). This center is the direction the engine needs to be moved to make an alignment of the engine and drive shaft.13. Inspect front and rear engine supports for damage. Make a replacement if necessary. Also, shims can be used to make an alignment of the engine and the drive shaft.14. Pull the drive shaft at least two feet out the rear of the transmission. Remove tooling (B). 15. Remove the plugs from fuel lines (18) and connect them. Remove the plugs from hydraulic lines (17) and connect them. 16. Position bracket (16) and tube assemblies (10). Install bolts (15). Install bolts and clips (14). 17. Connect eighteen tube assemblies (13) to the bracket. 18. Connect fitting (12). 19. Connect hose (11) to the retarder housing. 20. If housing (10) was removed, position it and install bolts (9) that hold it.21. Make