FILM 5P0834 - Caterpillar

2. The fuel temperature sensor is located behind right hand door assemblies (1) and (2).3. Disconnect wire harness (3) at the electrical connection. 4. Remove fuel temperature sensor (4) and the O-ring seal from tee (5). The following steps are for the installation of the sensor (fuel temperature).5. Make sure all components of the fuel temperature sensor are clean of dirt and foreign material prior to installation.6. Check the O-ring seal and components for wear or damage and replace if necessary.7. Install O-ring seal and fuel temperature sensor (4) to tee (5). Tighten fuel temperature sensor to a torque of 20 3 N m (177 27 lb in).8. Connect wire harness (3) at the electrical connection.9. Turn the fuel supply valve, located on the fuel tank, to the "On" position.10. Prime the fuel system. For the correct fuel priming procedure, refer to the topic "Fuel Priming Pump" in the 24H Motor Grader, Operations & Maintenance Manual.